Yamaha KX-W321 Owner's Manual page 7

DOLBY NR selector setting (in step 2)
Be sure to set the DOLBY NR selector according to the
system used for recording.
OFF: For a tape recorded with DOLBY NR OFF.
B: For a tape recorded with DOLBY B NR.
C: For a tape recorded with DOLBY C NR.
REVERSE MODE selector setting (in step 3)
The auto reverse function allows the tape running direction
be reversed automatically. Select an auto reverse mode
( , , or
RELAY
( ).
: When playback or fast forwarding (or rewinding) of
one side of a tape is finished, the deck stops at the
end of the tape.
Display during playback
The A or B indicator shown in
the display represents the
last deck operated.
KX-W421/
KX-W321
Peak level meters
Indicate the peaks of the signal levels during recording and playback over a –30 dB to +6 dB range. There are separate meters for each left
and right channel. These level meters have a peak hold function which holds the peak level for about 1.5 seconds.
To adjust the volume level
Use the volume control of the amplifier or receiver.
To use headphones
Insert the headphones plug into the PHONES jack. Since
the sound is also heard from the speakers, operate the
amplifier to cut off the sound from the speakers for private
listening.
) or manual reverse mode
Tape running direction
indicator (DECK A)
Tape counter
¤
L
— 30 dB 20 15 10
R
: Both sides of the tape are played back. After
playing, the deck stops at the end of the tape.
(When the tape running direction is set to ¤, only
the reverse side is played.)
: Both sides of the tape are repeatedly played back
(up to 8 times).
: Cassette tapes loaded in DECKs A and B
RELAY
are played back sequentially. (See "RELAY
PLAYBACK" on page 9.)
Tape running direction
indicator (DECK B)
‹ ¤
RELAY
A B
DUB NORM HIGH B C
8 6 4 2
Note
Never press the EJECT button when the tape is in motion.
Tape counter
‹
REC
0 2 4 6 +
7