Dubbing (From Deck A To Deck B) - Yamaha KX-W321 Owner's Manual

You can make dubbing from DECK A to DECK B. Open the cassette compartments by pressing the EJECT buttons and load a
blank cassette tape in DECK B and the original cassette tape in DECK A.
Example: KX-W421
Display during dubbing
NORM or HIGH
indicator lights during
dubbing.
1
1
Set the MODE selector to
or position.
If you select
, the reverse
RELAY
mode automatically switches to
.
MODE
"/[/"/
RELAY
To stop dubbing
Press the & button. (If you press the & button on DECK B,
both decks stop simultaneously and the dubbing mode is
cancelled. If you press the & button on DECK A, DECK A
stops immediately and then DECK B stops after recording a
4-second blank section.)
When the tape in DECK B reaches its end, DECK B stops
and then DECK A stops.
When the tape in DECK A reaches its end, DECK A stops
and DECK B stops after providing a blank section of about 4
seconds.
Available operations while dubbing
The Rec Return function can be carried out on DECK B.
Refer to "REC RETURN OPERATION" on the previous
page.

DUBBING (From DECK A to DECK B)

¤ ‹
A
DUB
L
– 30 dB 20 15 10
R
NATURAL SOUND CASSETTE DECK KX-W421
RESET
%
CLOSE
!
Cassette Stabilizer
DECK A
PLAYBACK
SEARCH
STANDBY/ON
MODE DOLBY NR EJECT
O / p / ∏ / RELAY
OFF/ B/ C
2
Set the
DIRECTION
or buttons for DECKs
A and B.
DIRECTION
Lights during dubbing.
¤ ‹
RELAY
B
NORM HIGH B C REC
8 6 4 2 0
DIRECTION DIRECTION RESET
%
CLOSE
PLAY ⁄ ! PLAY ⁄
RECORD/PLAYBACK
& &
MUTE/SEARCH REC/PAUSE
PLAY TRIM
0
DUBBING A # B EJECT
NORMAL HIGH
– +
3
Set the dubbing speed to either NORMAL
(normal speed) or HIGH (twice the normal
speed) with the DUBBING buttons*.
Dubbing starts automatically.
DUBBING A # B
NORMAL HIGH
* Higher quality sound will be obtained with the
NORMAL setting.
Note
During dubbing, Dolby NR is automatically set to off and the
recorded tape can be dubbed as is. (When the tape to be
dubbed is recorded with Dolby NR, this effect is also
dubbed.)
PLAY TRIM control adjustment (KX-W421 only)
For normal use, set the PLAY TRIM control to the center
position.
When the high frequencies sound is too noticeable or too
weak while monitoring the sound of DECK B, compensate
the high frequency response with the PLAY TRIM control
before dubbing. The compensated sound can be dubbed
onto DECK B.
As the compensation result depends on the quality of the
tape loaded in DECK A, the monitored sound cannot be
recorded as it is.
Refer to "PLAY TRIM CONTROL ADJUSTMENT" on page
9.
2 4 6 +
2
Cassette Stabilizer
DECK B
REC PHONES
BALANCE LEVEL
0
3
L R MIN MAX
The corresponding NORM
or HIGH indicator lights on
the display.
13