LEAD dynamic WCW Operating Manual page 7

ENGLISH
3
Control
3.1 ON/OFF
Press one of the buttons Z1-Z4 for more than 2 sec-
onds to switch the luminaires you have assigned to
this zone on or off. A blue light signals a switched on
zone and a yellow light signals a switched off zone.
You can assign any number of luminaires to a zone.
2. 1.
3.4 Save scenes
You can assign your zones up to 2 different scenes.
Select a zone (Z1–Z4) then the required dimming
level using the dimmer wheel and save it as a
scene by holding down a scene button (S1-S2) for
at least 2 seconds. Your luminaire flashes once as
confirmation.
LEAD ENERGY AG Am Stadtbad 37 45219 Essen-Kettwig
> 2 sec.
Subject to errors and amendments
3.2 Dimming = blue / 3.3 Light colour = yellow
3.2 Dimming
Dim your luminaire by first switching your controller
to 'Dim mode' (selector switch lights up blue), then
selecting a zone (Z1-Z4) and then adjusting the dim-
ming level using the colour/dimmer bar.
3.3 Control light colour
Change the colour of your luminaire by first switching
your controller to 'Colour mode' (selector switch
lights up yellow), then selecting a zone (Z1-Z4) and
then adjusting the dimming level using the colour /
dimmer bar.
2. 1.
3.5 Retrieve scenes
To retrieve a saved scene, first select zone (Z1-Z4)
and then the saved scene (S1-S2).
Information / Technical support: www.lead-energy.com