Advertisement
ASSEMBLY INSTRUCTION
NO:Q Ca rriag e Bolt M8
N O:Q-2 Acorn N ut for M8 Bol t (8 )
NO:Q-3 C urve d Washer
(8 )
NO:Q-13Screw M3* 14L (4)
STEP 1
1. I
nstall the front stabilizer (pt.K) with 2 carriage
bolts(pt.Q), semicircle washers (pt.Q3) and nuts
(pt.Q2) by using the hand tools. Make sure the
transportation wheels(pt.K1) are in correct
direction.
2. Assemble the Rear Stabilizer (pt.L) with 2
carriage bolts (pt.Q), semicircle washers (pt.Q3)
and nuts(pt.Q2) by using the hand tools. Adjust
the end caps(pt.L1) on the rear stabilizer to set
up a stable, balanced position.
After the assembly the bike can be adjusted to
slightly uneven ground by adjusting the height of the
foot caps in the back. The pre-assembled
transportation wheels in the front allow easy
movement
of the bike: therefore the
transportation-wheels need to point downwards to
the front.
STEP 2
1. Attach the Pedal hinge bolt R (pt.N7). Attach the entire
series crank (pt.M11) in the diagram.
Keep pedal axel bolt (pt.N7) in place with the wrench
and twist nylon nut 9 / 16 "x 6 mm (blue) (pt.N5)
counterclockwise with a wrench until it is properly
tightened.
2. Attach the pedal hinge bolt L (pt.N13). Attach the entire
series crank (pt.M1) according to the sketch.
Keep pedal axel bolt L (pt.N13) in place with the wrench
and twist nylon nut 9 / 16 "x 6 mm (red) (pt.N15)
clockwise with a wrench until it is properly tightened
3. Assemble Pedal connecting sheet (pt.N8) and crank
(pt.M11/M1, right / left).
4. Then mount the rear cover (Left / Upper) (pt.O2) and
rear cover (Left / down) (pt.O3) using the screws.
5. Then mount the rear cover (Right / Upper) (pt.O4) and
rear cover (Right / down) (pt.O5) using the screws
(Q13).
6. Please remove four sets of the Allen bolt (pt.E) and
semicircle washers (pt.E2) and spring washers (pt.E1)
from the Main Frame (pt.G).
3
Advertisement
