Advertisement
ASSEMBLY
1. Front grille
2. Blade locking cap
3. Blade
4. Guard knob
5. Rear grille
6. Motor shaft
7. Rotary switch
8. Oscillating knob
9. Motor housing
10. Power cord & plug
11. Fixing screw A
12. Upper pillar
13. Fixing screw B
14. Main pillar
15. Base
16. Pole fixing nut
17. Safety screw
● Carefully unpack the appliance and remove all the packaging materials
attached to your Fan. Pick out the base (15) and the pole sets (12~14),
remove the pole fixing nut (16) from the Main pillar (14) and insert the
Main pillar into the hole of the Base then tighten the Pole fixing nut (16).
● Release Fixing screw B (13) and adjust height to suitable length.
Re-tighten the Fixing screw B (13) once ready.
● Release the Fixing screw A (11), connect the Motor housing (9) with
the Upper pillar (12), fasten it with the Fixing screw A (11).
● Remove the Blade locking cap (2) and the Guard knob (4) from the
Motor shaft (6), secure the Rear grille (5) on the Motor housing (9) to
match with the three fixing pins, fasten the grille with Guard knob (4).
● Put the Blade (3) on the Motor shaft (6) and tighten it with Blade
locking cap (2).
● Put the Front grille (1) onto the Rear grille (5), settle it by the guard
fixing clip then fasten it with the Safety screw (17).
OPERATION
Unwind the power cable and Position the unit on a level, dry and flat
surface where the air outlet grilles cannot be obstructed. Position the
appliance at least 30 cm away from walls or obstacles.
Connect and ensure that the plug and the socket fit well.
Select the desired speed setting by rotating the Rotary switch. There are
3 speeds : 0 (Off), 1 (Low Speed), 2 (Medium Speed), 3 (High Speed)
Advertisement
