Table of Contents
Advertisement
The packing carton contains:
•
Wheeled base & foot tray
•
Mast and boom assembly
•
Adjustable knee pad
•
Leg opening handle
•
Document Wallet
•
Handcontrol
•
Battery charger
•
Battery pack
1. Remove all the parts from the carton and place on the floor, taking care
to protect the finish from damage.
SAFETY NOTE: Some of the parts are heavy and will need to be lifted with
care. Heavier assemblies may require two people to lift.
2. Apply the brakes on the rear castors of the base.
3. Fit the mast to the base. The mast fits into a rectangular hole in the top
of the base.
SAFETY NOTE: Possible finger trap. Keep fingers away from the end of
the mast when fitting to the base.
4. When the mast is fully engaged with the base, align the holes on the base
and mast with the hole on the foot tray and fully tighten the mast locking knob.
SAFETY NOTE: Make sure the mast is fully engaged as indicated by the
label on the side of the mast.
5. The knee pad is adjustable and can be moved up/down, in/out to suit the
client's needs. Adjust using the black knobs on the back and base of the knee
pad as shown on the illustration (page 6).
6. Remove the screw from the leg opening lever located at the rear of the
chassis. Fit the leg opening handle through the gate on the mast and push the
open end over the leg opening lever. Line up the notch in the handle with the
cross pin in the lever. Retain the handle with the screw removed earlier from
the leg opening lever.
6. Check the legs of the lift open and close satisfactorily.
7. Check the RED emergency stop button located on the controller is in off (out)
position.
8. Fit the handcontrol to the handcontrol socket located at the base of the power
pack.
4
Assembly and Commissioning Instructions
SF24 Iss.5 Nov.2011
Advertisement
Table of Contents
