Table of Contents
Advertisement
CEBORA S.p.A.
2 - SYSTEM DESCRIPTION
2.1 - Introduction.
Control panels art. 213, 216, 218 and 220 are the control panels of the power sources for TIG
SOUND DC 2640/T and TIG SOUND AC/DC 2540/T welding systems.
The remote control module art. 222 allows you to connect the aforementioned control panels
at a distance from the power sources.
2.2 - Technical specifications.
To review the technical specifications, see the Instruction Manual and Sales Catalogue.
2.3 - Description of control panels art. 213, 216, 218, 220.
The control panels are available in two versions for each power source:
− for power source art. 342, art. 213, minimum version and art. 216, complete version;
− for power source art. 348, art. 218, minimum version and art. 220, complete version.
The control panel is connected to the power source via the power cord, from the flyback
board, and the "RS485" standard communication cable, from the satellite board, and thus from
the control.
Each control panel is made up of three boards mounted on top of one another; one is common
to all versions, while the other two are configured the article that they represent.
The external panel board is the support for the entire control panel, and contains the indicator
leds (all except those relating to the "Process") and the function selection buttons.
The display board contains the display to show the sizes measured, the "Process" indicator
leds, and the potentiometers to adjust the functions.
The micro board contains the microprocessor that manages the entire control panel and
"RS485" communication with the satellite board of the power source. This board is programmed
with the version of the program corresponding to the article on which it is mounted.
The control panels are normally mounted in the housing provided on the side of the power
sources.
2.4 - Description of remote control module art. 222.
This is an optional unit that allows you to connect the control panel at a distance of up to five
meters from the power source.
The devices are connected via the extension cord art. 1190, which uses a fiber optic for data
communication, and an electrical cable for the control panel power supply.
Two boards are present to convert the signals from electrical to light and vice-versa:
-
optic interface on power source side code 5.600.763, which is placed on the power source
in the control panel slot.
-
optic interface on panel side code 5.600.768, which is placed remotely in the control panel
housing.
These two boards use the same power supply source as the control panel.
3.302.041
4
25/10/00
Advertisement
Table of Contents
