Embraer EMB145 Maintenance Manual page 10

(e) If necessary, apply solution again and rub.
CAUTION:
(f) The heavy dirt can also be removed with solvent MIL-PRF-680. For this, continue as
follows:
1 Soak a cloth in solvent MIL-PRF-680 and rub the dirty area to make the dirt soft.
2 Then remove the dirt with a dry cloth before solvent MIL-PRF-680 dries.
(2) To clean the aircraft, using the dry wash procedure do as follows:
CAUTION: DO NOT USE THE DRY-CLEANING PROCEDURE TO CLEAN TRANSPAR-
CAUTION: PUT ON GLOVES AND GOGGLES TO PREVENT INJURY TO YOUR SKIN
CAUTION: OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU PREPARE
(a) Apply the NUPOWER II using a Cotton flannel cloth to small areas at a time.
NOTE: Apply wet material to the area equally.
(b) Let it dry fully.
NOTE: Wait no more than 5-10 min even in the highest humidity conditions.
(c) Wipe the surface with a clean Cotton flannel cloth to remove the material.
K. Follow-on
SUBTASK 12-22-00-842-002-A00
(1) Open the inlets and outlets of the refrigeration pack compartments sealed before (AMM
21-50-00/1).
EFFECTIVITY: ALL
•
DO NOT LET SOLVENT MIL-PRF-680 TOUCH DOOR SEALS, LANDING
LIGHT LENS, POLYCARBONATE, WINDOWS, WINDSHIELD, AND
ACRYLIC PARTS TO PREVENT DAMAGE TO THEM.
•
FOR CLEANING OF THE LANDING LIGHT LENS, USE SOFT CLOTH
MOISTENED WITH ISOPROPYLIC ALCOHOL ONLY.
ENCY SURFACES (ACRYLIC OR POLYCARBONATE), OTHERWISE DAM-
AGE CAN OCCUR.
AND EYES.
AND APPLY CLEANING AND DISINFECTANT SOLUTIONS. IF THESE
PRODUCTS ARE STRONGER THAN THE ONES SPECIFIED, THEY CAN
CAUSE DAMAGE THE DECORATIVE SURFACES.
AIRCRAFT
MAINTENANCE MANUAL
12-22-00
600-802-A
Page 310
Apr 28/11