Operation; Safety Message - Omega 18207 Operating Instructions & Parts Manual

saddle
extension
screw
return spring
oil filler screw
release valve
Figure 1 - Model 18207 Nomenclature
WARNING
!
Study, understand, and follow all instructions
provided with and on this device. Do not exceed
rated capacity. This is a lifting device only. After
lifting, immediately transfer the load to appropri-
ately rated vehicle stands. Never work on, under, or
around a load supported by this device. Use only
on hard, level surfaces capable of sustaining rated
capacity loads. Do not move or dolly loads with
this device. Do not modify this device. Failure to
heed these markings may result in personal injury
and/or property damage.
handle
air hose
lift control valve
air motor
positioner
receptacle
wheel
3

OPERATION

Lifting (refer to Figure 1)
1. Assemble 3 pc. handle, ensure that each spring clip
aligns with and is secure in the corresponding
handle slot.
2. Chock the load to prevent inadvertent shifting and
movement.
3. Insert the handle into the positioner receptacle, tilt
jack and wheel it into position near the lift point.
4. With slotted end of handle, close the release valve
by turning it clockwise until the threaded valve offers
firm resistance to further tightening.

! SAFETY MESSAGE !

Use only the handle provided with this product or an
authorized replacement to ensure proper release
valve operation. Do not use an extender on the air
hose nor the operating handle. When using to lift
vehicle, lift only on the manufacturer's recommended
lift points and in accordance with the published
guidelines in your vehicle owners manual.
5. Insert and secure handle into positioner receptacle.
Squeeze the lift control valve until saddle contacts
load. To end air operation, simply release the grip
on the lift control valve. Never wire, clamp or other-
wise disable the the lift control valve to function by
any means other than by using the operator's hand.
6. Raise load to desired height, then immediately
transfer the load to appropriately rated support
devices such as jack stands.
WARNING
!
To avoid crushing and related injuries:
NEVER work on, under or around a load supported
only by a jack. ALWAYS use adequately rated jack
stands.