Advertisement
NOTE: Antennae wires may be secured to water pipe with electrical tape (not supplied) instead of or in
combination with tie wraps.
FIGURE 2
Insert the unit power cable terminals onto the plug-in power supply (transformer) screw terminals and fasten
securely. Plug the power supply into a standard 3 prong electrical wall outlet (refer to Figure 2). When energized,
the CLEARWAVE modulation indicator lights start fl ashing sequentially indicating that the unit is functioning
properly.
MAINTENANCE AND TROUBLESHOOTING
Power Surges and Lock Ups : Your CLEARWAVE is designed to
operate continuously, providing years of service. To reset the
CLEARWAVE, simply unplug the power supply from standard
wall outlet, wait 1 minute and then plug the unit back in to
standard wall outlet.
If you live in an area where power
surges are common, install a surge protector on the electrical
outlet that the CLEARWAVE power supply is plugged into.
Loose Antennae Wires : The antennae wires must be held tightly
against the water pipe and the coils must be pressed snugly
against each other to transfer the electromagnetic energy into
the water. If the antennae wires are loose, tighten them and
also retighten the wire ties. Be sure that the antennae wires are
wrapped in the proper direction (refer to Figure 2).
FIGURE 3
P/N 46402200 Rev F 04/17
page 6 of 8
Advertisement
