Launch CNC-603A User Manual page 2

LAUNCH
Important Safety Instructions:
⚫ Please read the manual carefully before using the instrument for proper operation!
⚫ Be careful when touching the device or hot parts of the engine.
⚫ If the power cord is broken, please do not turn the device on and use it. If the device is dropped or
damaged, please use it after being inspected by a professional.
⚫ Please do not hang the power cord on the edge of the table, chair or counter. Do not touch hot parts or
rotating fan blades.
⚫ If it is necessary to extend the power cable, the level of the power cord should be higher than or equal to that
of the original power line. Overheat may occur if a power cable of inferior level is used.
⚫ Do not connect the plug of power cord when not using the device. Do not remove the plug by pulling the
power line. It should be unplugged by hand.
⚫ The device should be cooled completely before storage and the line should be wound up.
⚫ The cleaning agent for the device is a flammable and weakly volatile liquid. Smoking and lighting fires are
strictly prohibited during the cleaning process.
⚫ The instrument should be placed in a room that is not exposed to direct sunlight and is well ventilated, and
signs "Smoking and lighting fires strictly forbidden" and "Danger warning of inflammables" should be
posted.
⚫ The operator's hair, clothes, fingers and other parts of the body should be kept away from the operating parts
of the equipment.
⚫ To prevent electric shocks, do you touch the operating equipment in wet areas or operate it in the rain.
⚫ Please operate the device as described in the manual. Use accessories recommended by the manufacturer.
⚫ It is strictly forbidden to open the ultrasonic system under the circumstances that ultrasonic cleaning agent
has not been added into the ultrasonic cleaning pool. Otherwise, the ultrasonic equipment may be damaged
easily.
⚫ The housing of the device must be reliable and grounded.
⚫ Automobile exhaust contains a variety of toxic and harmful gases (such as carbon monoxide, hydrocarbon,
nitrogen oxide and etc.). During the test, the exhaust should be directed outdoors and the room should be
well ventilated.
⚫ The temperature of the exhaust pipe and water tank of the automobile's engine is high. Do not touch them to
prevent burns.
⚫ Please pull up the handbrake of the vehicle to be cleaned, shift the transmission to neutral position and block
the front wheel before free disassembly cleaning.
⚫ Wear safety glasses when operating. Daily wear glasses are not safety glasses.
⚫ When disconnecting a pressurized fuel pipe union, please cover the union with a towel to avoid getting hurt
by fuel gushing out and causing fires.
⚫ Test solution is used by the main unit of the device uses, and ultrasonic cleaning agent is used for ultrasonic
cleaning.
: indicates where attention should be paid when operating the device.
: indicates the possibility of product damage and personnel injury during operation.
Please save the manual!
ii
CNC-603A Injector Cleaner & Tester User Manual