Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cyfral CC-4000
Summary of Contents for Cyfral CC-4000
- Page 1 CC-4000 CONTROL ELECTRONICS OPERATING, INSTALLATION AND PROGRAMMING MANUAL...
- Page 2 This manual applies only to the CC-4000 control electronics which is part of the CC4000 system. The description of programming and connecting with the rest of the system elements can be found in the CC4000 System Manual.
- Page 3 COMM: G Signal ground B Serial communication B A Communication series A S Audio speaker signal M Audio sound microphone H Differential video signal (positive) L Differential video signal (negative) SLAVE: +12V Positive supply of the panel ...
- Page 4 In addition, there is a factory table of opening codes in the memory which can be restored at any time. (It cannot be deleted by the installer/user). The CC-4000 electronics is powered by 12-13.8V and 40mA DC. It should be assumed that the power supply should have a current efficiency of 2.5A. The SLAVE panel is powered from its terminals.
- Page 5 COMM interface is a bus connecting in parallel all CC-4000 boards in a multi-input system. In a system in which there are single staircases without a hierarchy of inputs, this connector is left disconnected. Information is exchanged via this connector between all control electronics in the system and MASTER panels. It is recommended that the connection be made with UTP cable.
- Page 6 In the Video system, connect the DV-4 signal distributor to the CC-4000 PCB. It is connected with four wires to the terminals LINE "L +" "L-" "VH" "VL". It is necessary to remember that addresses programmed in distributors cannot be repeated.
- Page 7 It is possible to change the above settings using the GC-2000 programmer. It is connected to the "PRG" connector on the CC-4000 board. The settings edit window is shown below: With the programmer, you can archive settings on a computer disk, download pre-stored settings, edit opening...
- Page 8 IEW OF BOARD LED indicating that the Protection against supply voltage is present Slave panel short-circuit connector The bus connecting the frames in a multi-input system Power connector Master panel Line of the connector uniphones and videomonitors Adjustable audio Connector of the Device serial programmer potentiometers...
Need help?
Do you have a question about the CC-4000 and is the answer not in the manual?
Questions and answers