Table of Contents
Advertisement
Parameterization and operation
4.5.1
2-Channel RTC103 N-Module (Continued)
RTC MODULES / PROGNOSYS
RTC MODULES
RTC
OUTPUTS
CHANNEL 1
MIN DO SETTING
MAX DO SETTING
0/4 to 20 mA
CHANNEL 2
VOLUME
CHANNEL 1
VOLUME
CHANNEL 2
MODBUS
ADDRESS
DATA ORDER
DATALOG INTRVAL
PROGNOSYS
SET DEFAULTS
MAINTENANCE
RTC DATA
RTC MEASUREMEN
RTC ACTUAT VAR
DIAG/TEST
EEPROM
RTC COMM TO
RTC CRC
MODBUS ADDRESS
LOCATION
SOFT-VERSION
RTC MODE
RTC VERSION
36
Minimum DO set point corresponding to 0/4mA
Maximum DO set point corresponding to 20mA
Transfer range of 0/4 to 20 mA current loop as set in connected flow
measuring instrument.
same as CHANNEL 1
Aerated volume
same as CHANNEL 1
Start address of an RTC within the MODBUS network.
Specifies the register order within a double word. Presetting:
NORMAL
Indicates the interval in which the data is saved in the log file.
Activate or deactivate PROGNOSYS for RTC control. "Activate"
means if Measurement Indicator from relevant sensor decrease to
50% or lower RTC control do not use this measurement and switch
to adequate fall back strategy.
Restores the factory settings.
Specifies the value measured by the RTC, e. g. the influent
measurement.
Specifies the variable calculated by the RTC, e. g. whether the
aeration should be switched on or off.
Hardware test
Communication time-out
Communication check sum
Here, the address is displayed where the communication actually
takes place. Presetting: 41
Here, a location name can be assigned for better identification of the
RTC module, e.g. activation 2.
Shows the software version of the RTC communication card
(YAB117) in the sc1000.
Shows the installed RTC module variant, e.g. 1-channel closed-loop
control.
Shows the software version of the RTC module.
[mg/L]
[mg/L]
3
[m
]
[min]
Advertisement
Table of Contents
