2-Channel Rtc103 N-Module Parameterization On The Sc1000 Controller - HACH LANGE RTC103 N-Module User Manual

Parameterization and operation
4.4.3 1-Channel RTC103 N-Module VFD (Continued)
RTC MODULES / PROGNOSYS
RTC MODULES
RTC
MODBUS
ADDRESS
DATA ORDER
DATALOG INTRVAL
PROGNOSYS
SET DEFAULTS
MAINTENANCE
RTC DATA
RTC MEASUREMEN
RTC ACTUAT VAR
DIAG/TEST
EEPROM
RTC COMM TO
RTC CRC
MODBUS ADDRESS
LOCATION
SOFT-VERSION
RTC MODE
RTC VERSION
4.5

2-channel RTC103 N-Module parameterization on the sc1000 controller

32
Start address of an RTC within the MODBUS network.
Specifies the register order within a double word. Presetting:
NORMAL
Indicates the interval in which the data is saved in the log file.
Activate or deactivate PROGNOSYS for RTC control. "Activate"
means if Measurement Indicator from relevant sensor decrease to
50% or lower RTC control do not use this measurement and switch
to adequate fall back strategy.
Restores the factory settings.
Specifies the value measured by the RTC, e. g. the influent
measurement.
Specifies the variable calculated by the RTC, e. g. whether the
aeration should be switched on or off.
Hardware test
Communication time-out
Communication check sum
Here, the address is displayed where the communication actually
takes place. Presetting: 41
Here, a location name can be assigned for better identification of the
RTC module, e.g. activation 2.
Shows the software version of the RTC communication card
(YAB117) in the sc1000.
Shows the installed RTC module variant, e.g. 1-channel closed-loop
control.
Shows the software version of the RTC module.
In addition to the 1-channel version, there is also a 2-channel
version that can control two activated sludge tanks. The relevant
parameters therefore appear twice and are identified as channel
1 and channel 2.
[min]