Subscribe to Our Youtube Channel
Related Manuals for MGG S200
Summary of Contents for MGG S200
- Page 1 MGG Solar Powered Electric Fence Energisers Models S200 and S500 www.mggproducts.co.nz info@mggproducts.co.nz...
- Page 2 RFI (Radio Frequency Interference) Suppressed Circuitry. If for any reason you are not happy with your purchase, please return the energizer to MGG Products within 14 days of purchase and we will give you a full refund - guaranteed. If you have any questions regarding this product please email us: info@mggproducts.co.nz, or contact the...
- Page 3 children who will be unaware of the dangers of electric fencing, that a suitably rated current limiting device having a resistance of not less than 500 ohms be connected between the energizer and the electric fence in this area. The appliance is not intended for use by young children or infirm persons without supervision.
- Page 4 IPX4. This energizer complies with international safety regulations and is manufactured to international standards. MGG reserves the right to make changes without notice to any product specification to improve reliability, function or design.
- Page 5 3. Fence Terminal 4. Post Mounting Slot 5. Earth Terminal 6. Solar Panel 7. Battery 8. Battery Compartment Power source S200 S500 (12V 7.5 Ah SLA battery for both models) Maximum output Voltage up to 10.5 KV up to 11 KV Energy 0.17 J...
- Page 6 Unless otherwise stated, values are typical and normal production tolerances of ±10% should be allowed for Installing the battery 1 Place the energizer on a flat surface. Open the battery compartment by pressing the latches firmly (see diagram below). 2 Insert the battery. 3 Connect the positive (red) lead to the positive (+) terminal on the battery.
- Page 7 Connecting to an electric fence 1 Push a 1 m (3’3‛) earth rod fully into firm ground. 2 Connect the black lead from the Fence earth terminal on the energizer to the earthing system. 3 Connect the red lead from the Fence output terminal on the energizer to the fence. Make sure there is a good contact.
- Page 8 When fully charged, the battery should be able to power the energizer for over three weeks (0.15J model) or two weeks (0.5J model) with no sunlight. Warning! The battery must be disconnected and removed from the energizer before connecting it to a battery charger. Replacing the battery If a replacement battery is required, use a 12V, 7Ah, rechargeable lead-acid battery (suitable for all models).
- Page 9 If the energizer is stored for an extended period the battery may discharge and become damaged. The energizer should be stored inside, next to a window, where sunlight can shine on the energizer each day. If the energizer cannot be stored in a sunny position, it should be kept in a cool place. The battery should be fully charged and disconnected from the energizer.
- Page 10 Check that the energizer is adequate for the length of the fence. If necessary reduce the length of the fence or reduce the number of fence wires. Alternatively divide the fence-line into smaller zones, with each zone powered by a separate energizer.
- Page 11 2) Transport damage 3) Improper use, operation and refitting 4) Non-observance to the relevant safety instructions and work in the severe environments out of the recommended ones in this manual 5) Beyond installation and use areas of the relevant international standards 7) Influence of foreign objects and force majeure (lightning strike, overvoltage, severe weather, fire etc).
- Page 12 www.mggproducts.co.nz info@mggproducts.co.nz Website: Email: Phone: 09 401 6360...
Need help?
Do you have a question about the S200 and is the answer not in the manual?
Questions and answers