HSS Hire Globe Light Operating & Safety Manual

462_01_Globe Light 30/10/2012 10:59 Page 1
EQUIPMENT CARE
In the event that the bulb fails
1. Secure the base and then carefully
counter clockwise rotate the diffuser
and remove carefully.
2. Loosen the lamp securing screws,
slide the lamp securing element over
the lamp
3. Gently remove the bulb and replace
with a new identical bulb, re-attach
the lamp securing
carefully place the diffuser over the
lamp and tighten clockwise.
Ensure a good seal is achieved.
Never push the equipment beyond its design limits. If it
will not do what you want with reasonable ease and speed,
assume you have the wrong equipment for the job. Contact
HSS Hire for advice.
Keep the equipment clean - you will find this less of a
chore if you clean it regularly, rather than wait until the end
of the hire period.
Do not use any chemicals or solvents to clean the light,
wipe it over with a damp cloth or sponge.
When not in use, store the equipment somewhere clean,
dry and secure.
FINISHING OFF
Unplug the unit, allow it to cool and give it a clean.
Finally, neatly coil the power supply cable ready for
return to HSS Hire.
SPECIFICATIONS
Rated Voltage: 110volt
Electronic Ballast: (PF) 0.98
Frequency: 50Hz
Power (CFL): 57watt
Lamp Holder: GX24
(Diffuser) IP54
Protective Level:
(Panel Socket) IP44
Cable 1.5mm: x 5mtr
device and
... have you been trained
The law requires that personnel using this type of equipment in
the workplace must be competent and qualified to do so.
Training is available at HSS Training
If you have any suggestions to enable us to improve the
information within this guide please e-mail your comments or
write to the Safety Guide Manager at the address below
©HSS Hire Service Group Ltd 2012 No. 462/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
0845 766 7799
...any comments?
e-mail: safety@hss.com
462/01 462/01
Operating & Safety Guide 462
Operating & Safety Guide 462
Globe Light
Globe Light
Easy to use, temporary lamp.
Code 57336