1. Tube frame of the traction
unit
2. Long arm of the lift arm
assembly
3. Bolt (3/8 x 2-1/2 inches)
4. Washer (3/8 x 7/8 inch)
Note:
For proper operation of the rake, the
chains must be slack when the rake is in the
lowered (operating) position.
Note:
Make sure that all the finishing rakes
overlap properly, laying flat with none of the
chains tangled or twisted.
3
Removing the Rear Broom
from the Traction Unit
No Parts Required
Procedure
1.
Pivot the locking lever to the left (as viewed from
the rear of the machine) to unlock the adapters
(Figure
8).
Figure 7
5. Spacer
6. Chain
7. Locknut (3/8 inch)
1. Locking lever
g220791
2.
Lower the traction unit adapter.
3.
Grasp the adapter handle and lift the attachment
adapter while pivoting it back onto the
attachment
Note:
If the attachment adapter becomes stuck
to the traction unit adapter, insert a pry bar into
the pry slot to disengage the parts
1. Pry slot
5
Figure 8
2. Adapter handle
(Figure
8).
Figure 9
g005342
(Figure
9).
g003783