Pressure Pre-Set; Inflating Tires - Energizer EDC12035 Instruction Manual

Pressure Pre-Set

The pre-set pressure is factory set at 45
PSI when manufactured.
Press button 'set' for 3 seconds to
1
check the pre-set pressure. The
pre-set pressure is factory set at 45
PSI when manufactured.
Adjust your desired pressure by
2
pressing the buttons ▲/ ▼. Press
Button ▲ to increase the pressure
and press Button ▼ to decrease
the pressure. Once the desired
pressure is reached, the displayed
figure will flicker several times,
then return to 0.0 PSI. That means
the pressure is preset successfully.
The product is ready for inflating.
Press button 'set' to read gauge by
3
PSI/BAR.
Inflating tires
Roll out the 12 V cord and connect the
1
12 V adaptor to the outlet.
Adjust to your desired pressure.
2
(Refer to Pressure Pre-Set)
Screw the thread connection onto
3
tire's valve stem.
Move the On/Off switch to 'I' position
4
IMPORTANT
Do not adjust the pressure setting when the unit is operating, which would cause the
unit to stop. If the unit stops due to changing the setting, turn the ON/OFF switch
to off, then restart the unit.
and the Compressor will begin to operate.
The Compressor will automatically shut
off once the pre-set pressure is reached.
Press LED button for visibility in the
5
dark. Move the On/Off switch to 'I'
position to turn on LED. Move the On/Off
switch to 'O' position to turn off LED.
When car or bicycle tire's pressure
6
reaches pre-set pressure, the air
compressor will stop automatically.
Remove the thread connection from the
7
tire and disconnect the 12 V car adaptor.
NOTE
To avoid over-inflation of tires, please check
the recommended car tire pressure in the
vehicle's owner's manual or on the vehicle
placard located in the driver's door panel.
For bicycle tires, please check the tire
marking.
Inflating sports equipment and/or
small inflatables
Roll out the 12 V cord and connect the
1
12 V adaptor to the outlet.
Screw the ball/balloon adaptor into the
2
thread connection.
Insert the ball/balloon adaptor into valve
3
of the object to be inflated.
3