Jumper & Switch Setting - Biostar H410MHG Manual

Install an Expansion Card
You can install your expansion card by following steps:
• Read the related expansion card's instruction document before install the expansion
card into the computer.
• Remove your computer's chassis cover, screws and slot bracket from the computer.
• Place a card in the expansion slot and press down on the card until it is completely
seated in the slot.
• Secure the card's metal bracket to the chassis back panel with a screw.
for installing a VGA card.).
• Replace your computer's chassis cover.
• Power on the computer, if necessary, change BIOS settings for the expansion card.
• Install related driver for the expansion card.
Note
» Please be note that you will need to use M2 type screwdriver if you want to install or uninstall the
screw. It is recommended not to use a screwdriver that does not meet the specifications, otherwise
the screw may be damaged.
2.6 Jumper & Switch Setting
The illustration shows how to set up jumpers. When the jumper cap is placed on pins, the
jumper is "close", if not, that means the jumper is "open".
Pin opened
JCMOS1: Clear CMOS Jumper
The jumper allows users to restore the BIOS safe setting and the CMOS data. Please carefully
follow the procedures to avoid damaging the motherboard.
Clear CMOS Procedures:
1. Remove AC power line.
2. Set the jumper to "Pin 1-2 close", you can use a metal object like a screwdriver to touch
the two pins.
3. Wait for five seconds.
4. After clearing the CMOS values, be sure the jumper is "Pin 1-2 open".
5. Power on the AC.
6. Load Optimal Defaults and save settings in CMOS.
Pin closed
Pin 1-2 Open: Normal Operation (Default)
Pin 1-2 Close: Clear CMOS data
Chapter 2: Hardware installation | 13
H410MHG
(This step is only
Pin 1-2 closed