Alarm Codes And Possible Failures - AEG L7FE7261BI User Manual

14.1 Alarm Codes and Possible failures

The appliance does not start or it stops during operation. First try to find a solution to the
problem (refer to the tables).
WARNING!
Deactivate the appliance before carrying out any check.
With some problems, the display shows an alarm code and the Start/Pause button may
flash continuously:
If the appliance is overloaded, remove some items from the drum and/or
keep pressed the door while touching the Start/Pause button until the
indicator
Problem
The appliance does
not fill with water
properly.
The appliance does
not drain the water.
stops flashing (see the picture below).
Possible solution
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the inlet hose has no kinks, damages or bends.
• Make sure that the connection of the water inlet hose is cor-
rect.
• Make sure that the filter of the inlet hose and the filter of the
valve are not clogged. Refer to 'Care and cleaning'.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Make sure that the drain filter is not clogged. Clean the filter,
if necessary. Refer to "Care and cleaning".
• Make sure that the connection of the drain hose is correct.
• Set the drain programme if you set a programme without
drain phase.
• Set the drain programme if you set an option which ends with
water in the tub.
ENGLISH 41