Summary of Contents for Venture Products VENTRAC KX522
- Page 1 OWNER/OPERATOR’S MAN UAL & PARTS LIST SNOW BLOWER KX522 Re vised 01/08/20 09.10047...
- Page 2 Orrville, OH www.ventrac.com TO THE OWNER Prod uct Iden ti fi ca tion If you need to con tact an Au tho rized Ventrac Dealer for in for ma tion on ser vic ing your prod uct, al ways pro vide the Prod uct Model and Se rial num bers. Please fill in the fol low ing in for ma tion for fu ture ref er ence.
-
Page 3: Table Of Contents
TA BLE OF CON TENTS IN TRO DUC TION SEC TION A De scrip tion & Spec i fi ca tions ........A-1 SAFETY SEC TION B Safety Sym bols . - Page 4 If you have a Model 4000 tractor, an HT 12v Switch & Plug Kit (# 70.4046) is required. Ventrac KX522 Spec i fi ca tions Over all Height........58-1/2 inches Over all Length .
- Page 5 SAFETY AT TEN TION This sym bol iden ti fies po ten tial health and safety haz ards. It marks safety pre cau - tions. Your safety and the safety of oth ers is in volved. SIG NAL WORD DEF I NI TIONS In di cates an im mi nently haz ard ous sit u a - tion which, if not avoided, will re sult in death or se ri ous in jury.
-
Page 6: De Cals
SAFETY The fol low ing de cals must be main tained on your Ventrac At tach ment. If any de cals are faded or miss ing, con tact your dealer promptly for re place ments. De cal Page & Location Description Part Number E-7, #5... -
Page 7: Gen Eral Safety Pro Ce Dures
SAFETY Gen eral Safety Pro ce dures for Ventrac Trac tors, At tach ments, & Ac ces sories Read and understand the operator’s manual before operating this equipment. Observe and follow all safety decals. DO NOT let children or any untrained person operate the tractor or attachment. Make sure that all operators of this equipment are thoroughly trained in using it safely. - Page 8 SAFETY KX522 Safety Pro ce dures Be fore mak ing any re pairs or ad just ments, en gage the park ing brake, lower at tach ment to the ground, shut the en gine off, and re move the key. Read and un der stand the op er a tor’s man ual be fore op er at ing this equip ment.
-
Page 9: Attaching
OPERATION Attaching 1. Drive the tractor slowly forward into the hitch arms on the snow blower. Align the lift arms of the tractor with the snow blower hitch arms by raising or lowering the front hitch and complete the engagement. 2. -
Page 10: Belt Re Place Ment
MAIN TE NANCE/AD JUST MENTS Lu bri ca tion Grease the auger, jack-shaft, & blower shaft bearings every 25 hours. Do not over grease. Usually, one or two pumps is sufficient. Additional lubrication may be required in extremely harsh or dirty conditions. -
Page 11: Chute Ad Just Ment
MAIN TE NANCE/AD JUST MENTS Gear box Drive, Au ger Drive, & Top Au ger Drive Belt Re place ment 1. Re move the belt drive cover. 2. Re lease the belt ten sion spring and re move the old belt(s). 3. -
Page 12: Main Frame & Au Ger Drive
PARTS IL LUS TRATED DRAW ING MAIN FRAME & AU GER DRIVE... - Page 13 PARTS MAIN FRAME & AU GER DRIVE REF. PART NO. DE SCRIP TION QTY. 1 ..80.0369 ... . . AU GER, ASM KX522....... . . 1 2 .
-
Page 14: Main Drive & Fan Drive
PARTS IL LUS TRATED DRAW ING MAIN DRIVE & FAN DRIVE... - Page 15 PARTS MAIN DRIVE & FAN DRIVE REF. PART NO. DE SCRIP TION QTY. 1 ..90.0610 ... . . BOLT, 3/8-16 USS X 1 1/4 ......3 2 .
-
Page 16: Chute & Hydraulics
PARTS IL LUS TRATED DRAW ING CHUTE & HYDRAULICS... - Page 17 PARTS CHUTE & HY DRAU LICS REF. PART NO. DE SCRIP TION QTY. 1 ..62.0992 ... . . CHUTE, FI NAL EXT. SNOWBLOWER ......1 2 .
-
Page 18: Shields, De Cals, & Cut Ting Edge
PARTS IL LUS TRATED DRAW ING SHIELDS, DE CALS, & CUT TING EDGE... - Page 19 PARTS SHIELDS, DE CALS, & CUT TING EDGE REF. PART NO. DE SCRIP TION QTY. 1 ..97.0608 ... . . BOLT, CAR RIAGE 3/8 X 1 ......14 2 .
-
Page 20: 12 Volt Ac Tu A Tor De Flec Tor Control
PARTS/OP TIONS IL LUS TRATED DRAW ING 12 VOLT AC TU A TOR DE FLEC TOR CONTROL... - Page 21 PARTS/OP TIONS 12 VOLT AC TU A TOR DE FLEC TOR CON TROL REF. PART NO. DE SCRIP TION QTY. 1 ..30.0226 ... . . CLAMP, WIRE MT ADH. 3/8 GRAY ......2 2 .
-
Page 22: Top Auger
PARTS/OP TIONS IL LUS TRATED DRAW ING TOP AUGER... - Page 23 PARTS/OP TIONS TOP AU GER REF. PART NO. DE SCRIP TION QTY. 1 ..90.0508 ... . . BOLT, 5/16-18 USS X 1 ....... 4 2 .