Software Loading; Figure 3-3 Gtn Software Updater; Gtn Software Loader Card Creation - Garmin GTN 6 Series Maintenance Manual

3.2 Software Loading

3.2.1

GTN Software Loader Card Creation

NOTE
The application to create the GTN Software Loader Card runs on PCs with Windows
(Windows 2000, XP, Vista, Windows 7, and Windows 10). There is no Macintosh support at
this time.
NOTE
An data card reader is needed to create the GTN Software Loader Card using the
application that is downloaded from Garmin. The approved readers are SanDisk®
SDDR-999 and SDDR-93, although other data card readers may work.
A GTN Software Loader Card is created using GTN Downloadable Software and a data card with the GTN
software application. It is downloaded from the
Resource Center allows the technician to choose which software package(s) to load onto the card.
Create a GTN Software Loader Card as follows:
CAUTION
In order to create a GTN Software Loader Card, the drive that you select will be
completely erased.
1. Go to the Garmin
2. Download the GTN Software Loader Image. For the correct Software Loader Image part number,
refer to the Equipment List.
3. Connect a data card reader to the PC.
4. Insert the data card into the card reader.
5. Run the executable file.
6. Click Setup.
190-01007-B1
Rev. 4
Dealer Resource Center
Dealer Resource Center.

Figure 3-3 GTN Software Updater

GTN 6XX/7XX Part 27 AML STC Maintenance Manual
on Garmin's website. The Dealer
Page 3-3