TCP Direct 8 Series Instruction Manual

INSTALLATION INSTRUCTIONS

The basic Type number designation is described as follows:
T8040730E T8040735E T8040741E T8040750E
T8045330E T8045335E T8045341E T8045350E
Installation Instructions

PLUG and PLAY Procedure

1. Turn off the power to the light fixture at the breaker panel
before installation.
2. Open the diffuser from the light fixture.
3. Remove the fluorescent tubes. Please dispose of these
items properly as they contain mercury.
4. Put LED tube into the lighting fixture.
5. Install the LED tubes, close the diffuser.
6. Turn on the power
Fig.1 Before the installation Fig.1 Before the installation
Installation Instructions

Ballast by pass procedure

1.Turn off the power to the light fixture at the breaker panel before installation
2.Open the diffuser from the light fixture.
3. Remove the fluorescent tubes. Please dispose of these items properly as they
contain mercury.
4. Cut the wires shown as the diagram below.
5. Make the new wire connect to branch circuit shown as the diagram below.
6. Replace the cover over the wiring channel.
7. Install the LED tubes, close the diffuser.
8. Turn on the power.
INSTRUCTION MANUAL
LED GLASS TUBE T8 LAMP
Fig.2 After replacing the LED Tube