Advertisement
Quick Links
Introduction ............................................................................................................. 1
Model # CS665 Ordering Matrix ............................................................................ 1
Specifications .......................................................................................................... 2
Calibration .............................................................................................................. 2
Sensor Installation .................................................................................................. 2
Mechanical ........................................................................................................................2
Electrical ............................................................................................................................3
Sensor Cleaning ...................................................................................................... 3
11751 MARKON DRIVE • GARDEN GROVE, CA 92841 • 714.895.4344 • WWW.SENSOREX.COM
© Sensorex Corporation. All rights reserved. In the interest of improving and updating its equipment,
CS665 Steam-Sterilizable
Contacting Conductivity Sensor
Product Manual
Table of Contents
DESIGNED IN CALIFORNIA
ASSEMBLED IN CALIFORNIA AND CZECH REPUBLIC
Sensorex reserves the right to alter specifications to equipment at any time.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Sensorex CS665 Series
Summary of Contents for Sensorex CS665 Series
- Page 1 ASSEMBLED IN CALIFORNIA AND CZECH REPUBLIC 11751 MARKON DRIVE • GARDEN GROVE, CA 92841 • 714.895.4344 • WWW.SENSOREX.COM © Sensorex Corporation. All rights reserved. In the interest of improving and updating its equipment, Sensorex reserves the right to alter specifications to equipment at any time.
- Page 2 For example, choosing “0.1/cm” under Cell Constant would be B, “PT1000 RTD” for Temperature Compensation would be 1, “10 feet (3m), Standard Four-Wire Cable” under Cable Length would be BC, “Tinned Leads” under Cable Termination Connector would be 3, “Sensorex-Branded” under Branding would be A, and “1.5”...
- Page 3 Calibrate sensor according to meter/controller manufacturer’s instructions using known certified conductivity standards. Be sure and calibrate in large beaker or bucket, stirring sample with electrode. Avoid bubbles as much as possible; bubbles cause erroneous readings. Form: InstrCS665-Rev A [Rev: 2020-04-23] © 2020 Sensorex Corporation...
- Page 4 Follow wiring instructions supplied with your controller. Sensor Cleaning CAUTION INLET Do NOT clean sensors with an abrasive brush that INL ET could scratch the surface of the stainless steel. This will adversely affect the measurement. Form: InstrCS665-Rev A [Rev: 2020-04-23] © 2020 Sensorex Corporation...
Need help?
Do you have a question about the CS665 Series and is the answer not in the manual?
Questions and answers