Table Support
The table support must be installed as described to prop-
erly assemble your drill press.
To install the table support:
1.
Check to make sure the pinion is inserted into the
table support, as shown in Figure 4, so the pinion
and gear teeth mesh together.
2. Mark the top of the rack, as shown in Figure 5, to
keep track of which end is up.
3. Remove the column ring by loosening the Phillips
head screw, and remove the rack.
M1102/M1103 16-Speed Drill Press
Figure 4. Pinion correctly installed in
-12-
table support.