Handle M; Auxiliary Handle - DeWalt DCM5713 Original Instructions Manual

EngLIsh
Keep bystanders away.
Directive 2000/14/EC guaranteed
sound power.
Date Code Position (Fig. A)
The date code 33 , which also includes the year of manufacture,
is printed into the housing.
Example:
2017 XX XX
Year of Manufacture
Description (Fig. A)

WARNING:
any part of it. Damage or personal injury could result.
Variable speed trigger
1
Lock-off lever
2
Handle
3
Speed control switch
4

Auxiliary handle

5
Motor housing
6
Upper trimmer pole
7
Intended Use
This Grass Trimmer is designed for professional
trimming applications.
DO nOT use under wet conditions or in the presence of
flammable liquids or gases.
This is not an edger and is not intended to be used for edging.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS

WARNING:
personal injury, turn tool off and disconnect battery
pack before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.

WARNING:
and chargers.
Inserting and Removing the Battery Pack
from the Tool (Fig. B)
nOTE: Make sure your battery pack
34
Never modify the power tool or
Lower trimmer pole
8
Pole bracket
9
Guard
10
Spool housing
11
Battery housing
12
Battery pack
13
Battery release button
14
To reduce the risk of serious
Use only D WALT battery packs
e
13 is fully charged.
To Install the Battery Pack into the Tool
1. Align the battery pack 13
(Fig. B).
2. Slide it into the tool until the battery pack is firmly seated
and ensure that you hear the lock snap into place.
To Remove the Battery Pack from the Tool
1. Press the release button 14
out of the tool handle (Fig. B).
2. Insert battery pack into the charger as described in the
charger section of this manual.
Fuel Gauge Battery Packs (Fig. B)
Some D WALT battery packs include a fuel gauge which
e
consists of three green LED lights that indicate the level of
charge remaining in the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge button
. A combination of the three green LED lights will illuminate
15
designating the level of charge left. When the level of charge
in the battery is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
nOTE: The fuel gauge is only an indication of the charge left on
the battery pack. It does not indicate tool functionality and is
subject to variation based on product components, temperature
and end-user application.
Assembling the Pole (Fig. A, C)
1. To assemble the pole, line up the hole
trimmer pole 8 with the pin
2. Pull the pin out and slide the lower trimmer pole into the
upper trimmer pole 7 as shown in Figure C.
3. Release the pin and ensure it fully engages the hole.
4. Secure the poles by tightening the bracket wingnut
Attaching Auxiliary Handle (Fig. A, D)
1. Place the auxiliary handle 5
above the label placed in the middle of the pole.
7
2. Slide the bracket 19 of the auxiliary handle into the bottom
of the handle.
3. Thread the handle bolts
20
the handle.
4. Tighten the handle bolts with the wrench. Ensure the
handle is securely attached.
If adjustment is necessary, loosen the handle bolts and slide the
auxiliary handle up or down the trimmer pole. Then, retighten
the bolts.
OPERATION
Instructions for Use

WARNING:
instructions and applicable regulations.
with the rails inside the tool
and firmly pull the battery pack
16 in the lower
17 on the pole bracket 9 .
.
18
onto the upper trimmer pole
through the bracket and into
Always observe the safety