watt box WB-OVRC-UPS-1100-1 Owner's Manual
  1. Manuals
  2. Brands
  3. watt box Manuals
  4. UPS
  5. WB-OVRC-UPS-1100-1
  6. Owner's manual

watt box WB-OVRC-UPS-1100-1 Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

WELCOME TO WATTBOX™
WattBox power products are designed specifically to provide customers with advanced protection for their valuable electronics and custom
integrators with maximum flexibility for installation. Rest assured that WattBox products deliver the protection and safety for your customers' needs.
All WattBox products are UL certified and built with the highest-quality components available.
KEY FEATURES
Inlet Surge Protection –
Built-in protection for the UPS and all connected equipment against power surges.
Automatic Voltage Regulation –
mode and decreased in Buck mode.
Battery Backup for WattBox IP Devices–
outages and fluctuations. Batteries can be serviced without turning the UPS off.
Emergency Power Off –
Built-in contact for EPO.
PC Connection –
Built-in connections for PC access to the GUI and shutdown control to notify the PC when battery level is critical.
SNMP Card (sold separately) –
critical.
IMPORTANT – BATTERIES ARE DISCONNECTED FOR SHIPPING
When you receive your UPS, the internal backup batteries are disconnected from the circuit board for safety during shipping. Re-connect the wires
before installing the UPS.
Step 1
Remove front panel.
™
WB-OVRC-UPS-1100-1
Incoming power is monitored to avoid harmful over- or under-voltage conditions. Power is increased in Boost
Battery backup for powering critical equipment connected to a WattBox IP device during power
Use the SNMP card to access the GUI over Ethernet and notify devices on the network when the battery level is
Step 2
Connect the battery wires.
WB-OVRC-UPS-1500-1
Step 3
Replace the front panel.
OWNER'S MANUAL
WB-OVRC-UPS-2000-1
SURGE
PROTECTOR
$50,000

Advertisement

Table of Contents
loading

Related Manuals for watt box WB-OVRC-UPS-1100-1

Summary of Contents for watt box WB-OVRC-UPS-1100-1

  • Page 1 ™ OWNER’S MANUAL WB-OVRC-UPS-1100-1 WB-OVRC-UPS-1500-1 WB-OVRC-UPS-2000-1 SURGE PROTECTOR $50,000 WELCOME TO WATTBOX™ WattBox power products are designed specifically to provide customers with advanced protection for their valuable electronics and custom integrators with maximum flexibility for installation. Rest assured that WattBox products deliver the protection and safety for your customers’ needs.

  • Page 2: Package Contents

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual PACKAGE CONTENTS (1) UPS (2) Upright mounting bases (1) Owner’s manual (4) Rack mounting brackets (1) Detachable power cord (8) Mounting bracket screws (1) USB cable (1) CD FRONT PANEL 1. Power LED – Illuminates solid blue when the UPS is powered on. 2.
  • Page 3 WB-OVRC-UPS-1100/1500/2000 Owner’s Manual WB-OVRC-UPS-1100-1 REAR PANEL WB-OVRC-UPS-1500-1 REAR PANEL WB-OVRC-UPS-2000-1 REAR PANEL pg.3...

  • Page 4: Mounting Options

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual MOUNTING OPTIONS The WB-OVRC-UPS is designed for stand-alone applications and also for mounting in standard 19” equipment racks. Stand-alone Tower Step 1 Step 2 Step 3 Rack Mounting Step 1 Step 2 Step 3 Attach support brackets at the back of the Attach the rack ears to the UPS.

  • Page 5: Emergency Power Off (Epo)

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual CONNECTING TO WATTBOX OVRC DEVICE The WB-OVRC-UPS series is designed specifically for use with WattBox IP power surge protectors featuring a UPS link port. Connect the power cable from the outlet of the UPS to the power inlet of the wattbox, and connect a network cable between the UPS Link ports. Once the UPS has been connected to the WattBox, it will appear in the setup menu of the WattBox IP interface.
  • Page 6 WB-OVRC-UPS-1100/1500/2000 Owner’s Manual SNMP CARD (SOLD SEPARATELY) The SNMP card extends communication from the UPS to computers on the network running UPS software. Setup instructions and software are included with the card. SNMP Card Installation Turn the UPS off (Standby mode) and disconnect the power cord. Remove the SNMP card slot cover.
  • Page 7 WB-OVRC-UPS-1100/1500/2000 Owner’s Manual FRONT PANEL LCD OVERVIEW 100% CONVERTER SETTING 100% Function Display Description Backup Time Indicates configuration items. See details in “Menu Options” below. Configuration Info The exclamation indicates that a fault has occurred and the associated fault code is displayed below it.

  • Page 8: Menu Options

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual LCD MENU SETUP (UPS OFF IN STANDBY) Using the Menu Action Instructions Enter Setup With the UPS powered off in Standby mode, press and hold SELECT for three seconds to enter Setup. Menu Navigation Press ON/MUTE and SELECT to toggle between setup modes 1-7. Change Setting Press OFF/ENTER to configure the current setting on the screen.

  • Page 9: Normal Operating Modes

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual Normal Operating Modes Mode Description ECO Mode ECO (Efficiency Corrective Optimizer) mode is used when the input voltage is within voltage regulation range. The UPS powers the output directly from the mains and disables the internal fan to save energy. Buck Mode-AC Normal Buck mode is used when the input voltage is higher than the voltage regulation range but lower than the high loss point.

  • Page 10: Fault Codes

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual FAULT CODES Fault Code Icon Fault Type Remedy – Bus start fail Ensure batteries are securely connected. Check battery status. Battery may need to be replaced. If issue persists, contact WattBox Technical Support. – Bus over Power UPS off, then turn it back on. If issue persists, contact WattBox Technical Support.

  • Page 11: Troubleshooting

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual LCD ABBREVIATIONS Display Meaning Display Meaning Enable Disable Temperature Escape Battery Replacement Buck Mode Boost Mode TROUBLESHOOTING Symptom Possible Cause Remedy The UPS behaves as if power is out, The power cord is loose or damaged. Check the power cord connection to the outlet and to the but power at the outlet is normal.

  • Page 12: Battery Access

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual BATTERY REPLACEMENT (SERVICE PERSON ONLY) The UPS is equipped with user-replaceable batteries that can be hot-swapped while connected equipment is powered from the supply outlet. Contact WattBox Support to order replacement batteries. NOTE: With the batteries disconnected for replacement, connected equipment is not protected from power outages. NOTE: This UPS is equipped with internal batteries and only the service person can replace the batteries.
  • Page 13 WB-OVRC-UPS-1100/1500/2000 Owner’s Manual WB-IP-UPS-1100-1 TWO-BATTERY TRAY CONNECTION Step 1 Step 2 Step 3 Replace the batteries in the tray. Wire the Place the new battery packs in the tray as Place the cover back on the battery tray new batteries as shown above. shown above.

  • Page 14: Specifications

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual SPECIFICATIONS MODEL WB-IP-UPS-1100-1 WB-IP-UPS-1500-1 WB-IP-UPS-2000-1 1900VA/1710W @120V Output CAPACITY 1100VA/990W 1500VA/1350W 1740VA/1566W @110V Output INPUT Voltage 110/120V AC Acceptable Voltage Range 81-145V AC Frequency Range 60/50 Hz (Auto sensing) Power Outlet NEMA 5-15 NEMA 5-20 Power Inlet IEC C14 IEC C20 Surge Protection Modes...

  • Page 15: Important Safety Instructions

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS This manual contains important instructions that should be followed during installation and maintenance of the UPS and batteries. Temperature Rating Units are considered acceptable for use in a maximum ambient of 40 °C (104 °F). For Pluggable Equipment The socket-outlet shall be installed near the equipment and shall be easily accessible.

  • Page 16: Warranty

    WB-OVRC-UPS-1100/1500/2000 Owner’s Manual WARRANTY 5-Year Limited Product Warranty This WattBox product has a 5-Year Limited Product Warranty and a 5-Year Network Connectivity Warranty. The 5-Year Limited Product Warranty includes parts and labor repairs on all components found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to products which have been abused, modified, or disassembled.
  • Page 17 WB-OVRC-UPS-1100/1500/2000 Owner’s Manual If connected equipment damage was indicated on your RA request, WattBox requests the make and model of all connected equipment, a connection diagram of your system, as well as other requests based on the extent of the request for product placement or payment for connected equipment damage.
  • Page 19 200427-1016...

This manual is also suitable for:

Wb-ovrc-ups-1500-1Wb-ovrc-ups-2000-1

Table of Contents