Table of Contents
Advertisement
cegard/Pro CabSafe 2D Light Curtain
4.5
Integration
The following precautions must be followed when the
cegard/Pro (CabSafe 2D) light curtain is integrated
into a CabSafe System:
-
The cegard/Pro (CabSafe 2D) light curtain must
be connected to the CabSafe Controller (see
user manual "CabSafe 3D sensor and CabSafe
Controller").
-
For static installations
(CabSafe 2D) light curtain, a door position signal
has to be provided that informs the CabSafe
Controller about the door position (signal from
the elevator control or from a sensor).
-
The max. door speed shall not exceed 0.5 m/s
(1.64 ft/s).
4.6
Installation
4.6.1
Alignment
The optical axis of the emitter (Tx) and the receiver
edge (Rx) need to be aligned towards each other to
ensure the light curtain functions reliably.
4.6.2
Mechanical installation
WARNING
Electrical and mechanical
Hazards
Electrical shock and unexpected movement of the
protected application can cause serious injury or
death.
► Follow all applicable safety measures.
► Use only specific and approved tools.
► If the cegard/Pro (CabSafe 2D) light
curtain has to be adjusted, the main power
supply must be switched off and marked as
out of service.
► Connection cord with length exceeding 2 m
(6.56 ft.) shall be protected in a raceway.
NOTICE
Mechanical damage to the
cegard/Pro (CabSafe) 2D light curtain
► Do not drill additional holes into the light
curtain.
► Do not overtighten the mounting screws.
► Mount the edges on a flat surface
► Do not bend the edges during transport or
during the installation.
© CEDES | V 1.0
of the cegard/Pro
CEDES AG reserves the right to modify or change technical data without prior notice.
Important:
► Switch off main power to the control unit and
mark clearly that this system is out of service be-
fore performing any work on the system.
1.1
1.2
1.3
2
English
Receiver and
emitter need to
mount at the
same height
and both con-
nectors are on
top.
Check the
alignment of
the edges. The
receiver needs
to be mounted
180° to the
emitter.
Important:
Make sure the
optical ele-
ments are fac-
ing each other
For back side
or side mount-
ing: mark the
mounting
holes.
Drill the holes
for mounting
on the marked
positions.
6/14
Advertisement
Table of Contents
