Table of Contents
Advertisement
4
Completely secure the first module. Use a
3/16" Allen Bit/5mm Hex Drive, tighten all
Clamps with a standard drill or torque
wrench.
Torque to 8.3Nm (6.1ft-lb).
NOTE: To prevent damage to module and
KBK Clamp, do not exceed recommended
torque setting above.
Do not use hammer drills, impact drivers, or
long Allen keys.
5
Continue installing modules until the end of
the array. Once complete, move to the next
column of modules.
Use your Spacing Diagram to determine the
required gap between columns.
Repeat steps 2-5 until the entire array is
complete.
NOTE: KBK Clamps are designed for single
use only. If KBK Clamps are removed for
maintenance purposes, please re-install
using a new KB Konnect Clip.
Rev.1, Sep 2019
Figure 34 –KB Konnect Clamp + End Block Installed
Figure 35 – Installed Array
Page 29 of 42
Advertisement
Table of Contents
