Table of Contents
Advertisement
Removing Collected Water
2
Use the continuous drainage option from the middle hole
Note:
Water can be automatically emptied into a floor drain by attaching a 14mm
inner diameter hose (not included).
1.
Remove the continuous drain cap (1) by turning it counterclockwise, then remove
the rubber stopper (2) from the spout.
2. Screw the drain connector (included)
to the spout by turning it clockwise.
ATTENTION:
When using the continuous drainage option from the middle hole, place the unit
on a level surface and make sure your garden hose is clear of any obstructions
and is directed downward. Placing the unit on an uneven surface or failing to
attach the hose properly may result in water filling up the chassis, which will
cause the unit to shut off. If this occurs, empty the water in the chassis and
check to make sure that both the unit and the hose are properly set up.
3. Insert the drainage hose into the
drain connector.
25
Advertisement
Table of Contents
