Advertisement
step 4: attach back panel
**
FAILURE TO FOLLOW ALL DIRECTIONS ON THIS PAGE MAY RESULT IN UNEVEN DOOR ALIGNMENT
Begin by installing all of the screws along one
edge of the back panel. Next, using a square
or tape measure, make sure that the cabinet is
square. (If using a tape measure, the distance
from one corner, diagonally to the other corner
should be the same in both directions.) If not,
apply gentle pressure to the diagonally opposite
corners to shift case into alignment. Re-measure
to ensure equal distances. Install the remaining
screws, starting with the corners.
(H10) x 29
(H11) x 6
small pan head
metal plate
screw
4.1. Make sure the screws go through the pre-drilled holes properly.
4.2. Do not over tighten screws.
10
**
hole for anti-tip kit
Advertisement
