Table of Contents
Advertisement
STEP 3
Move cabinet into its final position. Fasten
cabinet to wall STUDS and/or adjacent cabi-
nets as
required.
STEP 4
Insert large drawers into cabinet body by extending all 4 slides. Insert the 4
Drawer Slides into these extended slides. Push drawer inward in a gentle
rocking motion. When slides are properly inserted you will hear a clicking
sound.
Close and re-open drawer. Drawer should slide freely. If drawer binds, one
or more slides was probably not correctly aligned during drawer insertion.
Installing drawers with double slides can be tricky. If you encounter resistance,
check alignment and repeat above instructions. In some cases it may be easier to
first attach the 2 left slides and then attach the 2 right slides. Slides are released by
pulling the two plastic levers up or down.
If slides are forced, the race that holds the ball bearing may become bent causing
dislodged ball bearings. Loose ball bearings can be set back into the race and the
race can be straightened using a small flat tipped screwdriver.
Six Drawer Base Cabinet
NEVER FORCE SLIDES
Adjacent Cabinet Mount Parts
4 x M6-20 Hex Head Bolts
4 x 6 mm Hex Nuts
Wall Mount Parts
4 x Drywall Screws
4 x Fender Washers
Page 7
Advertisement
Table of Contents
