Sony HDC5500 Operating Instructions Manual page 49

PAINT
Page name Item
Page No.
<SHUTTER> SHUTTER
P16
ECS FREQ
<NOISE SUPPRESSION
SUPPRESSION>
P17
<FLICKER REDUCTION
REDUCTION>
P18
POWER LINE
FREQUENCY
MODE
GAIN
OFFSET
ACM TYPE
<HDR OPERATION> HDR MODE
P19
SDR GAIN
HDR CONTRAST
HDR BLACK OFFSET
HDR KNEE
POINT
SLOPE
HDR WHITE CLIP
LEVEL
HDR BLACK CLIP
HDR BLACK
COMPRESSION
Settings
ON, OFF, (ON), (OFF)
29.97PsF: 1/40, 1/60, 1/100,
1/120, 1/125, 1/250, 1/500,
1/1000, 1/2000
25PsF: 1/33, 1/50, 1/100,
1/125, 1/250, 1/500, 1/1000,
1/2000
24PsF/23.98PsF: 1/32, 1/48,
1/96, 1/100, 1/125, 1/250,
1/500, 1/1000, 1/2000
59.94P: 1/100, 1/125, 1/250,
1/500, 1/1000, 1/2000
50P: 1/60, 1/125, 1/250,
1/500, 1/1000, 1/2000
29.97PsF: 29.97 to 2700 Hz
25PsF: 25.00 to 2300 Hz
24PsF/23.98PsF: 24.00 to
2200 Hz
59.94P: 59.96 to 4600 Hz
50P: 50.03 to 4600 Hz
0 to 100%
ON, OFF
ON, OFF
50, 60
STANDARD, ACM
–99 to +99, 0
0 to 99
1, 2, 3, 4
OFF, LIVE HDR
0.0 to –15 dB, –6.0 dB
100 to 566%, 200%
–99.9 to 99.9, 0
OFF, ON
–99 to 99, 0
–99 to 99, 0
OFF, ON
–99 to 99, 0
OFF, ON
OFF, ON
49
Description
Settings in ( ): When a remote control unit/panel or a
CCU is not connected (cannot be changed)
Step shutter selection
Note
When you turn REDUCTION ON or OFF, noise may
be generated. This is not a malfunction.
Specifies the frequency of the lighting power source.
STANDARD: Corrects flicker without adding an image.
ACM: Corrects flicker by adding images.
Enabled only when STANDARD is selected.
Sets the correction gain.
Enabled only when STANDARD is selected.
Sets the brightness level that invokes correction.
Enabled only when ACM is selected.
Selects the combination of frames to add. More frames
are added as the value increases.
Displays the CCU setting.
Enabled only when LIVE HDR is selected.
Gain setting applied to the SDR output.
Enabled only when LIVE HDR is selected.
HDR output contrast ensured by setting SDR GAIN
(display only).
Enabled only when LIVE HDR is selected.
HDR output black offset
Enabled only when LIVE HDR is selected.
KNEE setting applied for HDR
Sets whether to clip at 0% and lower in the HDR
output.
Set to OFF (fixed) when <OUTPUT FORMAT> t
FREQUENCY t OETF is set to S-Log3.
Sets whether to compress low-luminance areas in the
HDR output.