Troubleshooting - EINHELL SPK1 Original Operating Instructions

10. Troubleshooting

Fault
Pump does not
cut in
Pump cuts out and
in constantly
Pump does not cut
out
Anl_Durchflussschalter_SPK1.indb 13 Anl_Durchflussschalter_SPK1.indb 13
GB
Possible cause
- Power failure
- Pump not switched on
- No transport fl uid is being dischar-
ged, the output line is adequately
pressurized
- Output side leaking
- Output side leaking
- Consumer open
- 13 -
Remedy
- Check the cable and fuse
- Switch on pump
- Open consumer
- Check consumers and output line
for leaks
- Check consumers and output line
for leaks
- Close consumer
02.12.15 08:33 02.12.15 08:33