Advertisement
Maintenance
Assembly, maintenance and repair work may only be carried out by persons trained in maintenance and repair work on wet
jet systems and high-pressure systems. Use only spare parts approved by Suttner GmbH. Only use components (hoses,
connectors, etc.) approved for the respective pressure and temperature range.
Every year, check that the spray gun is safe to use. Arrange to have any defects immediately rectified by an expert.
Are the markings and inscriptions legible?
Does the spray gun close automatically?
Does the safety latch work?
Does the spray gun show signs of mechanical damage?
After max. 1000 operating hours or a year or if hot water (exceeding 90°C) and chemicals are used after 500 operating hours or 6 months:
Check valve parts (seal seat, O-rings, support rings, ball, piston rod, pressure piece) for damage and if necessary replace completely with a
Suttner repair kit.
After max. 3000 operating hours or 3 years or if hot water (exceeding 90°C) and chemicals are used after 1500 operating hours or 18 months:
Replace valve parts (seal seat, O-rings, support rings, ball, piston rod, pressure piece) completely with a Suttner repair kit.
Disposal
Please dispose of old equipment in an environmentally friendly manner.
Old equipment contains valuable recyclable materials which should be salvaged for recycling. Please therefore dispose of old equipment at
suitable collection points.
Information regarding Pressure Equipment Directive 2014/68/EU
The product is classed as a pressure-maintaining component within the terms of Pressure Equipment Directive 2014/68/EU. Due to the
operating parameters, it comes under the scope of Article 4 / Paragraph 3 of this guideline ("good engineering practice") and therefore no
Declaration of Conformity and CE marking are allowed!
www.rm-suttner.com
Advertisement
