Run The Application - Murata SN8000 EVK User Manual

SN8000 EVK User Guide
Download complete
Note:
If the EVB is not recognized by the programming tools, it may be necessary to disconnect
and then reconnect the board to the computer before trying again. The following message
indicates there was an error with the download process:
"**** OpenOCD failed - ensure you have installed the driver from the drivers
directory, and that the debugger is not running **** In Linux this may be due
to USB access permissions. In a virtual machine it may be due to USB
passthrough settings ****"
Resetting target
make: *** [run] Error 1

3.4 Run the application

This section assumes you have successfully completed previous section, and the scan application is running
on the SN8000 EVB.
After power-on-reset, the scan application prints status messages to the USB UART of the SN8000 EVB.
To verify printing, launch a terminal application such as Microsoft® Hyper Terminal. (For Windows XP,
it's located at START > All Programs > Accessories > Communications > Hyper Terminal)
Use following settings on COM port connected (in this example it's COM 18):
Page 22 of 30