Table of Contents
Advertisement
SN8000 EVK User Guide
Note: ensure that the SN8000 EVB is NOT connected to the PC prior to installing the WICED SDK.
Choose the installation folder for the WICED IDE and click Next, then choose the installation workspace
folder for the WICED SDK and click Install. Once the installation completes, click Finish to immediately
.
start the WICED IDE
2.4.2 Connect the SN8000 Evaluation Board
The SN8000 EVB connects to the PC through USB. The USB interface provides +5V power as well as
individual JTAG and UART interfaces to the STM32F205 onboard SN8000 EVB.
Figure 4 SN8000 EVK Configuration
Note: Do NOT plug the EVB into PC prior to installing the WICED SDK. Run Broadcom WICED SDK
installer first so that USB driver for SN8000 EVB can be loaded properly.
The SN8000 EVB has two logical USB devices: a USB-JTAG device and a USB-UART device. USB
drivers for the EVB were automatically installed during the previous SDK installation process.
Plug the SN8000 EVB into the development PC with a USB cable, the driver should automatically load.
Page 14 of 30
Advertisement
Table of Contents
