Table of Contents
Advertisement
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance has a pilot, which must
be lit by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle on
the floor.
WHAT TO DO IF YOU SMELL GAS:
1. Do not try to light any appliance.
2. Do not touch any electric switch; do not
use any phone in your building.
3. Immediately call your gas supplier from a
neighbor's phone.
supplier's instructions.
4. If you cannot reach your gas supplier,
f i r e - p a r t s . c o m
call the fire department.
1. STOP! Read the safety information above on
this label.
2. Push in gas control knob slightly and turn
clockwise to "OFF".
GAS OUTLET
CONTROL
KNOB
Pilot Adjustment
Screw
NOTE: Knob cannot be turned from "PILOT" to
"OFF" unless knob is pushed in slightly. Do not
force.
3. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow "B" in the safety
information above. If you don't smell gas, go to
next step.
1. Turn knob clockwise from "ON" position to the "PILOT" position. Push in the gas control knob slightly
and turn clockwise to "OFF".
FOR YOUR SAFETY READ BEFORE LIGHTING
Follow the gas
LIGHTING INSTRUCTIONS
GAS INLET
Pilot Gas
Supply
LIGHTING INSTRUCTIONS
Do not force knob.
C. Use only your hand to push in or
turn the gas control knob. Never
use tools.
push in or turn by hand, do not try
to repair it.
service technician.
D. Do not use this appliance if any
part
has
Immediately
service technician to inspect the
appliance and to replace any part
of the control system and any gas
control,
underwater.
4. Find pilot – follow metal tube from the gas control
behind the burner pan.
Pilot Burner
Thermocouple
5. Turn knob on gas control counter-clockwise to
"PILOT".
6. Push in control knob all the way and hold in.
Immediately light the pilot with a match.
Continue to hold the control knob in for about one
minute after the pilot is lit. Release knob and it
will pop back up. Pilot should remain lit. If it
goes out, repeat steps 3 – 7.
* If knob does not pop up when released, stop and
immediately call your service technician or gas
supplier.
*
If the pilot will not stay lit after several tries, turn
the gas control knob to "OFF" and call your
service technician or gas supplier.
7. Turn gas control knob counterclockwise to "0N".
If the knob will not
Call a qualified
been
under
water.
call
a
qualified
which
has
been
7
Advertisement
Table of Contents
