Quick Setup - MERIT INDUSTRIES Megatouch SLIM MAXX Owner's Manual

COPYRIGHT © 1999 MERIT INDUSTRIES, INC.
MEGATOUCH
UNPACKING & SETTING UP YOUR
MEGATOUCH™ SLIM MAXX VIDEO
GAME
1. Upon opening the carton and removing
the packing materials, lift the game out
of the box and remove it from the
plastic bag. Place the game on a sturdy,
level surface.
2. Locate and remove the vinyl pouch
containing the manuals, warranty card
and keys (located on top of, or on the
back of, the cabinet.) Put the manual,
warranty card and keys aside for future
use. Clean any adhesive residue that
may be left on the cabinet after
removing the vinyl pouch.
3. Plug the power cord into a grounded AC
outlet.
NOTE: INSIDE THE POUCH ARE SEVERAL
SETS OF KEYS: TWO SETS, EACH,
UNLOCKS THE REAR DOOR AND THE
COINBOX.
4. Turn the power switch to "ON" (see
Figure 9 on page 15 of the manual.)
5. Turn on the game and wait for the game
to go through its boot-up sequence. At
the completion of the boot-up sequence,
the game will display the main menu
screen.
CALIBRATING THE TOUCHSCREEN
1. Press the "CALIBRATE" switch located
in the coinbox section or CPU section
of the unit (See Figures 9 and 12 on
pages 15 and 16 of the manual.)
2. With your index finger, touch the
center of the first circle that appears on
the screen. NOTE: YOU MUST HOLD
1 MEGATOUCH™ SLIM MAXX OWNER'S MANUAL
™
SLIM MAXX

QUICK SETUP

YOUR FINGER ON THE CIRCLE FOR
APPROXIMATELY 2 SECONDS FOR
THE CALIBRATION
RECOGNIZED. Once touched a
second circle will appear on the screen.
3. With your index finger, touch the
center of the second circle that appears
on the screen.
4. Once the second circle is touched, a
crosshair will appear on the screen. To
test the calibration of the screen, touch
the crosshair with your finger and slowly
drag your finger around the screen. The
crosshair should follow your movement.
Touch the EXIT TEST icon.
ADJUSTING THE VOLUME AND MONITOR
CONTROLS
NOTE: THE VOLUME AND MONITOR
CONTROLS ARE PRESET AT THE
FACTORY AND, THEREFORE, MAY NOT
NEED TO BE ADJUSTED.
1. In the countertop, the volume control is
accessed through the software; to
access the volume control, press the
SETUP button, located in the coinbox
section or in the CPU section of the
game, then touch the SYSTEM
SETTINGS icon at the Setup Screen,
then touch the VOLUME CONTROL
icon.
2. Adjust the Monitor Controls, in the CPU
section of the game (See Figure 9 on
page 15 of the manual), as necessary
to achieve the desired picture.
TO BE
PM0240-01