Initial Operation; Assembly; Mains Connection; Setting Up - Grizzly HWW 3819 InoxInox Translation Of The Original Instructions For Use

• Do not carry or fix the equip-
ment by the cable.
• Use only extension cables that
are protected from spray wa-
ter and designed for outdoor
use. Always fully unroll a cable
drum before use. Check the
cable for damage.
• Before any work on the equip-
ment, during work breaks and
in the case of non-use, remove
the plug from the socket.
• The cross-section of mains
connection lines must be no
smaller than rubber hose lines
with the designation H07RN-F.

Initial Operation

Assembly

• To permanently install the home wa-
ter dispenser, screw it to the ground.
Screwing it to a fixing panel will pre-
vent the appliance from moving.
Mind not to obstruct the access to the
draining screw (
All screw connections must be fit-
ted with a sealing strip if the dome-
stic water pump is used inside the
house.

Mains Connection

The pump you have purchases is already
fitted with an earthed plug. The pump is
intended for connection to an earthed
socket at 230 V ~ 50Hz.

Setting up

• Place the unit on a firm, horizontal,
non-flooding surface.
A
8).
• Always put up the domestic water sys-
tem at a point higher than the water
surface you wish to pump water from.
Where this is impossible, install a low
pressure-resistant shut-off implement
between the appliance and the suction
hose (Available from specialist retailers).
The pressure vessel (
show an air pressure of 0.15 MPa
(1.5 bar) in an unused condition.
Check the air pressure before the
initial start-up.
The air pressure can only be
checked with an external pressure
gauge, e.g. with a tyre filler. The
mounted manometer only shows
the water pressure.
• Regulate the pressure in the pressure
A
vessel ( 5) by removing the protective
cap for the air valve (
valve protective cap (
ing air into the pressure vessel via the
B
air valve ( 16) or allowing air to vent.

Connecting the hoses

On the suction side, attach a hose
with reflow stopper and install a
prefilter (Available from specialist
retailers). On the suction side, do
not use any quick-action connec-
tion systems.
All screw connections must be fitted
with a sealing strip if the domestic
water pump is used inside the house.
Air in the suction hose will stop the
house water dispenser from working
properly. Observe the directions in
the chapter "Filling the Pump".
GB
A
5) must
B
14), undoing the
B
15) and pump-
25