WAREMA KNX SA 2M230 AP Series Installation Instructions

Installation instructions
KNX SA 2/4/6/8M230.x AP
Keep for future use!
Valid from 1st February 2020
General information
Fig. 1 KNX SA 8M230.16 AP
The KNX SA 2/4/6/8M230.x AP sun shading actuator is a
device for the central operation of up to eight sun shad-
ing drives 230 V AC (the following uses the sun shading
actuator for eight motors with 16 push button inputs as an
example).
The device is operated using a KNX bus system. The
drives and the motor control unit are supplied via a
230 V AC control line.
Intended use
The KNX SA 2/4/6/8M230.x AP was developed to control
sun shading products. The approval of the manufacturer
must be obtained for any use of the device other than its
intended purpose specified in these instructions.
Safety instructions
W ARNING
The electrical installation must be per-
formed by a certified electrician in accord-
ance with the electrical installation regu-
lations published by the Association of
German Electrical Engineers (VDE 0100)
or the standards and legal requirements
of the country in which the device is being
installed. The electrician must observe the
installation instructions included with the
supplied electrical devices.
W ARNING
If hazard-free operation cannot be
assumed, the device may not be started or
must be deactivated. This assumption is
justified if:
 the housing or the connecting lines show signs of
damage,
 the device is no longer working.
2016157_b•en•2020-02-01
W ARNING
It is important to comply with the following
points in the interest of personal safety.
Children may not play with the operating elements of
the control unit or the remote control. Store remote
controls out of reach of children.
Make sure that no persons or objects are in the range
of movement of the driven parts (blinds, external vene-
tian blinds, etc.).
Disconnect the device from the operating voltage if
cleaning or other maintenance work must be per-
formed.
Function of the sun shading actuator
You will find a detailed description of the software func-
tions for the KNX sun shading actuators in the manual
(art. no. 2014 787). You can download the manual and
the product database of the sun shading actuator from
www.warema.com.
Installation
Insert a slotted screwdriver (recommendation: 3.0 -
4.0 mm blade) into a cover opening (Fig. 3) and carefully
pry open the hinged cover. Repeat the procedure for the
second opening of the cover. After both latches have been
unlatched,
the cover can be removed. Open the second cover in
the same way. Alternatively, the AP model may also be
mounted on a DIN rail (TH 35-15 in accordance with EN
60715: 2001).
Electrical connection
An on-site overload current protection device (fuse) and a
disconnecting and isolating switch to switch off the entire
system must be provided.
The electrical connection is made as shown in the wiring
diagram on the reverse side (Fig. 4), the connection to
the KNX bus system and the drives is made using spring
terminals, the connecting lines are designed as screw
terminals.
W ARNING
All terminals and connections under cur-
rent must be covered completely against
touching by the latched cover. It should not
be possible to open the latched cover with-
out using tools.
We reserve the right to make technical changes
1