mibeTec HERPOtherm Instructions For Use

mibeTec HERPOtherm Instructions For Use

Advertisement

Instructions for use
Simple quick well-tolerated
A medical device for the symptomatic treatment of cold sores

Intended use

HERPOtherm
is a patented medical device for the local treatment of symptoms that accom-
®
pany cold sores (herpes simplex labialis) such as itching, burning, tingling or tightness.
HERPOtherm
can normally prevent the development of cold sore blisters if applied early
®
enough. If applied later, the severity of symptoms may be lessened, or they may fade sooner.
The first signs of an outbreak (so-called prodromal symptoms) are generally itching, burning,
tingling or tightness.

How it works

HERPOtherm
works solely by concentrated heat and is thus completely free from chemicals.
®
Hence, HERPOtherm
is also suitable for pregnant women, allergy sufferers and children.
®
The application of concentrated heat (local hyperthermia) is a physical mode of action based
on a brief, concentrated application of heat to a small, limited area of skin. Even a localised
pulse of heat may be sufficient to relieve symptoms such as itching, burning, tingling or tight-
ness and, if applied early enough to normally prevent the formation of cold sore blisters.

Administration

HERPOtherm
is very simple to use:
®
– Remove the protective cap from the device. Place the ceramic contact plate of the device
onto the affected skin area and gently press it against the skin.
– Press the button and the ceramic contact plate will heat up to a temperature of around
51°C. Once this temperature is reached, a LED will light up. The LED will go off once the
device automatically shuts down after 3 seconds of use. At the start of the heating-up
phase and at the end of treatment, you will hear an additional acoustic signal.
– Place the protective cap on the device.
For persistent or recurrent symptoms, multiple treatment of the same skin site is possible.
Please leave a treatment interval of at least 2 minutes between each application. Do not ex-
ceed a maximum number of 5 applications per hour on the same skin area.

Directions for use

HERPOtherm
is indicated only for self-administration by adults and children aged 12 years
®
and older. In children under 12 years of age, it should be used only with the assistance of an
adult.
To prevent virus transmission and for reasons of hygiene, HERPOtherm
used by one person.
Cold sores are a viral disease caused by the herpes simplex virus. It is transmitted by droplet
infection, by direct contact or as a smear infection.
There is no permanent cure for infection with the herpes simplex virus.
Cleaning information:
The ceramic contact plate of the device can be easily cleaned with a standard alcohol disin-
fectant wipe; all other external surfaces, for example, with a clean cloth.
GI03269-02_Herpotherm_UK.indd 1

Battery replacement:

INSERT BATTERY (CR2 3V)
3
To change the battery, the protective cap and battery cap must be removed and refitted after
inserting the battery (see illustration).
When the battery needs changing, the LED will flash 3 times and the acoustic signal will
sound 3 times.
Do not use rechargeable batteries.

Warnings

HERPOtherm
– eyes and eyelids
– mucous membranes
– open wounds, damaged skin (e.g. open blisters)
– scalded or burnt skin
– frostbite
– small-fibre neuropathy, allodynia, hyperalgesia
– tumours and malignant changes of the skin
– people with reduced sensitivity due to physical or medical complaints
– sensitive skin areas or skin areas with poor blood supply.
Medical advice should be sought in the following cases:
– persistent symptoms while using HERPOtherm
– worsening symptoms while using HERPOtherm
should stop using the device.
Furthermore, the device must not be used:
– immediately after application of ointments, creams, lotions etc. on the affected site.
– on moist skin.
Depending on sensitivity, the treatment temperature may cause some discomfort.
In sensitive individuals, a temporary reddening of the skin may occur after use. In rare cases,
users with sensitive skin types may experience skin irritation.
The device indicates failure by flashing the LED 5 times and sounding the acoustic signal
5 times. This may occur if used incorrectly, e.g. if the user triggers and operates the device
in the air instead of on the skin. If this error message occurs repeatedly despite proper use,
should only ever be
®
please contact the manufacturer or distributor.
Do not use the device if damaged or in case of obvious malfunction. Do not use damp or
damaged batteries. Protect the device from moisture.

Storage instructions

Store the device protected from direct sunlight and in a dry place.
Do not use the battery beyond the expiry date which is stated on the battery. In order to avoid
damage to HERPOtherm
prolonged periods of non-use (inactivity).
PULL OFF
2
UNSCREW
1
must not be used in or on
®
.
®
. Until these have been clarified, you
®
due to leaking battery acid, the battery should be taken out during
®
05.02.2019 13:18:22

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HERPOtherm and is the answer not in the manual?

Questions and answers

Summary of Contents for mibeTec HERPOtherm

  • Page 1 5 times. This may occur if used incorrectly, e.g. if the user triggers and operates the device adult. in the air instead of on the skin. If this error message occurs repeatedly despite proper use, To prevent virus transmission and for reasons of hygiene, HERPOtherm should only ever be ®...
  • Page 2 Croydon, United Kingdom, CR0 2BX Tel.: +44(0)2038707504 E-mail: customerservice@mibe.de www.herpotherm.eu Please contact the manufacturer or distributor if you have any questions about the device or how it works. Date of revision of the text: December 2018 Please read the instructions for use.

Table of Contents