Nanoptix Ultra System Wireless Quick Setup Manual

Quick Setup Guide - Nanoptix Ultra System Wireless
1. Shut down all gaming terminals
2. Remove Game Controller black boxes (C) from packaging and place inside each gaming terminal that you
wish to monitor with the system.
3. Connect each Game Controller black boxes (C) to the game terminal using cables (A) & (B) along with the
red wire taps (included).
4. Cable (A) part # 210029-0302R "WHITE-GREEN-BLACK"
•
Attach the white wire (PULSE IN) to the gaming terminal's "credits in" hard meter or directly to the
coin mech, bill acceptor, etc. using the enclosed red wire taps
•
Attach the green wire (PULSE OUT) to the gaming terminal's "credits out" hard meter using the
enclosed red wire taps
•
Attach the black wire (GND) to the ground connection of the gaming terminal's power supply using
the enclosed red wire taps
5. Cable (B) part # 210029-0121R "BLUE-RED-BLACK"
•
Attach the blue wire (FORCE CASHOUT) to the gaming terminal's "knock off" button using the
enclosed red wire taps
•
Attach the red wire (+12Vdc - SUPPLY VOLTAGE) to the +12 VDC of the gaming terminal's power
supply using the enclosed red wire taps.
•
Attach the black wire (GND) to the ground connection of the gaming terminal's power supply using
the enclosed red wire taps.
6. Install Spill Proof printer (E) at the bar/counter (for further info refer to the Spill Proof Printer Owner's Manual)
7. Connect the Host Game controller (F) to the Spill proof printer (E) using cable (D)
8. Connect the Control box (G) to the Host Game controller's (F) left RJ12 receptacle
9. Power ON the Spill Proof printer (E) with paper loaded
10. Turn ON all gaming terminals, if the installation was completed correctly, within 60 seconds the control box
(G) lights corresponding to the connected games will be illuminated.
11. Additional cables (not shown) are used for advanced programing and firmware updates
Web: WWW.NANOPTIX.COM
Email: support@nanoptix.com
Phone: 888.983.3030
Document no: 102814 -0010R – GR March 2020