Basalte DESEO KNX Installation Manual

DESEO KNX
Installation Manual
Safety instructions
Before operating the unit, please read this manual thoroughly and retain it for future reference.
Failure to observe these instructions might damage the device.
The device may only be installed and connected by professional electricians.
All relevant rules and regulations valid in the country of use, as well as KNX guidelines, apply.
Description
The Deseo room controller allows the operation of all functions within a room. Deseo combines touch-sensitive technology with a
1.7" oled display. The 4 touch-sensitive touchsensors allow you to navigate through all functions.
Light, scenes, blinds, heating and cooling, ventilation and even the multiroom audio system can be controlled by Deseo. By touching the
upper and lower sensor at the same time the multi-touch will be activated and a welcome or goodbye scene can be triggered.
Components
Deseo KNX
Model No. 300-02
Front
B
A
D
H G
Rear
K
29V
KNX
Important advice
• Avoid obstacles which might obstruct the proper mounting of the cover on the switch, such as round headed screws,
plastering or textured wall paint.
• Installing Deseo on a metal or a mirrored surface might cause the device to not function properly.
• The minimum gap between 2 Deseos must be at least 2 cm, preferably 4 cm.
• Do not install any device nearby that might cause interference such as fluorescent lights or RF devices.
• Never connect the device to 230V or in the vicinity of it. Make sure to maintain the distance specified in the applicable
standards and regulations.
• Not mounting the Deseo front cover correctly may result in a poor sensitivity of the touch sensors. Please make sure to always
push the front cover onto the Deseo switch as far as possible.
E
F C
Deseo front cover
Model No. 301-xx
(Not included)
P
O
R
A 1,7" OLED-display
B Touch sensor up
C Touch sensor down
D Touch sensor left
E Touch sensor right
L F
Opening to screw the device into the backbox
G Guide for the Deseo front cover
J
H Temperature sensor
I
KNX connector
J
External power supply
I
K Programming button
L Programming LED
M Display
N Touch sensor up
O Touch sensor down
P Touch sensor left
Q Touch sensor right
R Opening temperature sensor
N
Q
M