Remote Control Function - Zephir ZRP9000CB Manual

LED DISPLAY
The display indicates the current setting temperature or the timer setting. When the set temperature or the timer is
adjusted, the new setting is shown then the display returns the current set temperature.
※ The display is also used to show error codes should a fault occur, see ERROR CODES.

REMOTE CONTROL FUNCTION

1. POWER
2. MODE
3. TIMER
4. SPEED
5. TEMP+
6. TEMP-
7. SLEEP
NOTICE
This unit can evaporate the condensation and distribute through the exhaust hose
automatically.
1. When the unit is in the cooling function, it does not need the drain pipe installed.
Please make sure that the rubber cap is locked on drain hole, when the unit is
running.
2. When operating the dehumidifying, the "B" rubber cap on drain hose should be pulled out and install a proper drain
hose.
On/Off switch
MODE selector
Hourly programming
Fan speed selector
Temperature selector up
Temperature selector down
Night operation selector