Programmable Timer - Zephir ZRP9000CB Manual

1. POWER KEY
Press to turn unit "ON" or "OFF".
2. TEMP- (DOWN)
During cooling function：This key lowers the preset temperature by 1℃ each time it is pressed and the minimum
limit is 16℃.
3. SLEEP CONTROL FUNCTION
While in cooling mode, press the SLEEP key to set the temperature. It increases1 ℃ after an hour and at most
increases 2℃ after 2 hours.
Press the SLEEP key again can cancel the setting.
4. SPEED
Press to select either LOW, MEDIUM, or HIGH fan speed.
5. TEMP+ (UP)
During cooling function: This key raises the preset temperature by 1℃ each time it is pressed and the maximum limit
is 31℃.

6. PROGRAMMABLE TIMER

Programmable timer ON/OFF key.
TIMER-ON: The timer-on is used to turn on the unit automatically after the set time is over.
1. Press the "TIMER" key at stand-by status , then set the time you desired by pressing "TEMP+" or "TEMP-" key
2. Once the set hour has come to an end, the unit will turn on automatically.
3. Press the "POWER" key before time out, the setting time will be canceled and the unit will turn on.
4. You can set the function and fan speed while setting the timer.
TIMER-OFF: The timer-off is used to turn off the unit automatically after the setting time is over.
1. Press the "TIMER" key at operating status ,then set the time you desired by pressing "TEMP+" or "TEMP-" key.
2. Once the set hour has come to an end, the unit will turn off automatically.
3. Press the "POWER" key before the time out, the setting time will be canceled and the unit will turn off.
7. MODE
Press this key to select cooling,heating, fan, dehumidifying.
ALARM
When the water tank is full,"E2" will be displayed on the display panel. To resume operation, please remove the rubber
cap of the drain hose to drain out the water firstly. The E2 warning will disappear after draining, and then you can restart
the unit by pressing the POWER key.