Advertisement
OCCURRENCE
POSSIBLE
CAUSE
SOLUTION
WATER
Residue left in tub.
Washer is overloaded.
Do not overload washer. See Washing
Wash load too wet after
Procedures,
spin.
Load is out of balance.
Rearrange load to allow proper spinning.
Drain hose is kinked.
Straighten drain hose.
Water
does
not
enter
Water supply is not adequate in area.
Check another faucet in the house. Wait until
washer
or
it
enters
water supply and pressure increase.
slowly.
Water supply faucets are not cornpletely
Fully open hot and cold faucets.
open.
Water is being used elsewhere in the house.
Water pressure must be at least 30 psi (260 kPa).
Avoid running water elsewhere while washer is
filling.
Water
level
does
not
Water inlet hoses are kinked.
Straighten hoses.
cover load.
Improper water level selection (for models
Select higher water level/load size.
with
water level/load size control).
Washer is overloaded.
Do not overload washer. When control is set at
highest fill level, dry load level should not be
higher than top row of circular holes in wash tub.
Warm or hot water is not
Hot water heater is set too low or isa distance
Measure hot water temperature at nearby faucet
hot enough,
from washer,
with
candy or meat thermometer.
Water
temperature should be at least 130°F (70°C).
Adjust water heater as necessary.
Hot water is being used elsewhere in the
Avoid using hot water elsewhere before or during
house,
washer use. There may not be enough hot water
available for proper cleaning. If problem persists,
your hot water system may be unable to support
more than 1 use at a time.
Water in washer does not
Drain hose is kinked or clogged.
([lean and straighten the drain hose.
drain or drains slowly.
Water leaks.
Fill hose connection at faucet or washer.
Check and tighten hose connections. Install rubber
sealing washers provided.
House drain pipes are clogged.
Unclog drain pipes. Contact plumber if necessary.
Oversudsing.
Use less detergent.
Incorrect wash and rinse
Hot and cold water hoses are connected to
Connect hot water hose to hot water faucet and
temperatures,
wrong supply faucets,
cold water hose to cold water faucet.
Water is entering washer
Drain hose standpipe is incorrect height.
but tub does not fill.
Standpipe must be a minimum of 33" (83.82 cm)
high to prevent siphoning. See INSTALLATION
INSTRUCTIONS.
10
Advertisement
