Advertisement
4.12.9.
When you are within 2% of the programmed value, the LED will display RED and you will also feel the vibration of the handle.
Once you achieve (+/- 2Nm), the buzzer will emit a quicker sound sequence.
4.12.10. When you are over 2% of the programmed torque, the buzzer will emit a continuous tone and the LED will turn GREEN and you will
also feel the vibration of the handle.
4.12.11. Press
button to switch to ANGLE measuring,
the wrench will self-test a few seconds, and show target angle and display 0°.
4.12.12. Press
button to change clockwise or counter-clockwise direction. A "MINUS" symbol will appear in front of the displayed value for
counter-clockwise direction.
4.12.13. The LED light will be GREEN when you are under 50% of the programmed Angle value.
4.12.14. As you approach the target Angle value, the LED light will turn YELLOW.
4.12.15. When you are within 2% of the programmed Angle value, the LED will turn to RED.
4.12.16. When the programmed Angle has been achieved, the buzzer will sound and the handle will vibrate.
4.12.17. When you are over 2% of the programmed Angle, the LED turns to GREEN and the handle will vibrate.
4.12.18. Press
button, the screen will show
4.12.19
Press
button to quit Angle measurement mode, the display will show
ATTENTION: When you hear the continuous tone, stop pulling immediately, especially in case the target torque/ angle is low.
Caution:
Never use the torque wrench when it has a low battery. The wrench's accuracy will be affected.
"----" will be shown on the screen, when applying torque is exceeded at 100% of the maximum torque value.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
BATTERY REMOVAL
Remove the batteries. Dispose of according to local government guidelines.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of
products containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance
scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without
prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: This product comes with a lifetime guarantee against manufacturing defects. Proof of purchase is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
to zero the Angle reading for the next application.
01284 703534
sales@sealey.co.uk
Original Language Version
will be shown on the screen. Hold the wrench still and stable,
and return to torque measurement mode.
www.sealey.co.uk
STW309
Issue: 2 (F) - 27/02/19
Advertisement
