Pebble Grey GLENDALE 800.10.30 Assembly Instructions

Led

Advertisement

LED Illuminated Mirrors

800.10.30
800.10.31
800.10.32
GLENDALE
Back board holes (Fig A)
REAR VIEW
B
Portrait Mounting
Thank you for purchasing our product.
Please read through these instructions carefully and refer back to them
during installation to ensure that your product is fitted safely and that it
retains its high quality finish.
Please retain for future reference.
Please Note that a distance of 150mm is required between the infra-red
sensor switch and any other object to avoid any unnecessary
interference.
A
C
REAR VIEW
D
Landscape Mounting
Min. 150mm
- page 1 -

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GLENDALE 800.10.30 and is the answer not in the manual?

Questions and answers

Summary of Contents for Pebble Grey GLENDALE 800.10.30

  • Page 1 LED Illuminated Mirrors 800.10.30 800.10.31 800.10.32 GLENDALE Back board holes (Fig A) REAR VIEW REAR VIEW Landscape Mounting Portrait Mounting Thank you for purchasing our product. Please read through these instructions carefully and refer back to them during installation to ensure that your product is fitted safely and that it retains its high quality finish.
  • Page 2 When unpacking the mirror ,please handle with care .Always lay the mirror on a soft flat surface. Specific information list (Fig B) Distance (mm) (mm) (mm) (mm) Art No 800.10.30 800.10.31 800.10.32 Installation: Fixing mirror (Fig C) 1. Position the mirror in a suitable location (according to the zonal diagram ( Fig 1) on the back page) ensuring that the mains supply cable is within reach of...
  • Page 3 These mirrors are suitable for Zone 2 or higher and not Zone 0 or 1(see diagram above). (Fig 1) Wiring Diagram (Fig 2) How to isolate the sensor so you can switch ON & OFF with a mains switch. How the mirror is wired. How to isolate the sensor.

This manual is also suitable for:

Glendale 800.10.31Glendale 800.10.32

Table of Contents