Advertisement
Quick Links
Wiring
Having correctly identified the wiring from your existing light
fitting, pull the wire through the hole and connect to the
SUPPLY
NEUTRAL
EARTH (GREEN/YELLOW)
SWITCHED LIVE
Check that...
• You have correctly identified the wires
• The connections are tight
Commissioning
• Refit the mirror panel by fixing the side screws back in
place.
• Replace fuse or circuit breaker and switch on. Your light
is now ready for use.
• We recommend cleaning with a soft dry cloth. Do not use
solvents or abrasive cleaners as these could damage the
finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Safety information
Live Voltages may be present in this unit even when turned of or when completely disconnected. For your safety,
always switch off the supply before changing lightbulbs, or cleaning.
The mirror must be replaced immediately should it become cracked or damaged. This fitting must
not be used without the mirror in place.
Replace Cracked Shade
connection block inside the product in the following way:
LIGHT FITTING
BLUE (N)
GREEN/YELLOW
BROWN (L)
• No loose strands have been left out of the connection
block.
• Activate your new LED mirror by swiping your hand in
front of the sensor.
• Mirror – Use a damp cloth or a propriety glass cleaner.
Do not use abrasive materials as these will damage the
finish.
Iss.4 27032017
Endon Lighting LS9 0SE
Instruction leaflet
Liz Mirror
52034
Advertisement
Related Manuals for Endon Liz
Summary of Contents for Endon Liz
- Page 1 Wiring Instruction leaflet Having correctly identified the wiring from your existing light connection block inside the product in the following way: fitting, pull the wire through the hole and connect to the Liz Mirror SUPPLY LIGHT FITTING NEUTRAL BLUE (N) 52034 EARTH (GREEN/YELLOW) GREEN/YELLOW SWITCHED LIVE BROWN (L) Check that... • You have correctly identified the wires • No loose strands have been left out of the connection • The connections are tight block. Commissioning • Refit the mirror panel by fixing the side screws back in • Activate your new LED mirror by swiping your hand in place.
- Page 2 This product is suitable for use in Zone Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory Ceiling 2 and outside Zones of a bathroom. operation of this product. Please retain these instructions for future reference. ZONE OUTSIDE ZONES See diagram. If this unit is being fitted in a room containing a bath or 0.6m shower, a 30mA RCD must be used, in Warning accordance with IEE regulations. 2.25m 0.6m This is a Class 1 product and must be earthed This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped. ZONE Please read these instructions carefully before commencing any work. This product is not suitable for dimming. This unit must be fitted by a competent and qualified This product is rated at IP44. electrician. Waste electrical products should not be disposed of with Install in accordance with IEE Wiring regulations and household waste. Please recycle where facilities exist. current Building Regulations. Check with your local authority or retailer for recycling advice.
Need help?
Do you have a question about the Liz and is the answer not in the manual?
Questions and answers